2013 Mercedes-Benz Sprinter Logo

Related Topics:

A
Anonymous Posted on May 07, 2014

Where is thottle valve actuator located on a 2014 sprinter

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I need to locate the blend door mode actuator for the REAR (Auxiliary?) area of a 2014 GMC Acadia. I know where the actuators are located for the driver and passenger areas, but not the rear.

Look under the chassis and locate where the heater and a/c hoses enter the car. That will give you the general location of the evaporator and air ducts. You will need to remove the plastic side covers to locate the actuators.
1helpful
1answer

My 2014 Mercedes sprinter will not start

That sounds like a low or dying battery. What is your battery voltage?
0helpful
1answer
0helpful
1answer
0helpful
1answer

Push gas pedal to fast and the car dies when warmed up but fine when cold

that is a bad idle air control valve. it is located on the thottle body next to the thottle position sensor
0helpful
1answer

Idle cotrol vale

Its on the side of the thottle body, two 10mm bolts hold it on, its cylinder shape and will have bright metal on the ends of it, with a wiring harness plugged in on one side, if you locate the air cleaner follow the black intake tube up to the engine, the black tube hooks onto the thottle body, then on the side should be the idle air control valve.
2helpful
1answer

P2106 and p061b and the truck (05 f-150) wont start.

p2106 Throttle actuator control system-Forced limited power.

the tp sensor/s in your thottle body is the problem. the most common repair is to replace the thottle body, some people just replace the tp sensors.

It also can be a broken wire to the injector.
3helpful
1answer

Where is the EGR valve located on a 2001 Ford Windatar ? I want to replace it as I have an error code P0401

it is located beside the thottle body, but this code is insufficient flow, which the port in your thottle body is stopped up with carbon, you will have to remove the thottle body , take some carb cleaner and a pick and clean the port out.
1helpful
2answers

At 10k service dealer changed oil and did an

The reprogramming preformed is due to a fault in the EGR valve causing faulty actuation. The actuation of the valve prevents soot acumulation in the valve. excessive soot build up could cause the valve to stick. the reprogramming preformed is to prevent this... as for the whine.. I dont think this would be a result of the reprogram.. best of luck
Not finding what you are looking for?

291 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...