2000 landrover disc. rear signals not working but front signals are can anyone please help

Have you checked the light bulbs?

it all points to a fault with a common ground. Find earthing points

I would suspect the turn signal switch is defective, that is the most common cause.

The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

check the front right bulb

I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems

1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

under the dash on the drivers side should be the other one... as that is a fiberglass body... check all the grounds on the offending lights to make sure they are making contact

Robert

Please take a moment to rate this solution thanks

Pull the light back out, turn the turn signal on, take a test light, ground it. stick down into the connector. A lot of times, the little metal tabs on the bottom don't make contact and it will cause this problem. Somtimes, you have to replace the connector. Also, if the front light blinks fast, check the bulb in that one - it could be shorted. Hope this helps. Phil

sound like you have a poor earth on the rear lights or indicator circuit