Codes detected
SOURCE: Have error codes C1175 &
C1175
ABS/TCCM
Anti-lock braking / traction control
LH rear wheel speed sensor circuit fault
ABS/TCCM to wheel speed sensor signal circuit (FH33-21): open circuit,
short circuit to ground, short circuit to B+ voltage, high resistance
LH rear wheel speed sensor failure
P1000 is for check not complete after last memory clear , dont worry about it , just stick with C1175 , and most probably it is the sensor wire
SOURCE: can you tell me what these two codes are P1000 and
Po code 1000 is system readyness test, it means it has not met all condtions or flags since last reset of the computer. and the other
C1165-Wheel speed sensor circuit right rear electrical failure and C1235-Wheel speed sensor circuit right rear signal failure
Possible Source(s):
SOURCE: What is a c1145 code and c1155?
the error codes you are looking for are
C1145 Speed Wheel Sensor RF Input Circuit Failure
C1155 Speed Wheel Sensor LF Input Circuit Failure
there are many reasons this could be if you recently had tires changed or rotated. it would be good to make sure they did not leave them disconnected. Best to take it to a professional and have it checked out as these are important sensors.
thanks and have a great day
SOURCE: Ihave a 2003 Jaguar S-Type, What do PO133, PO153
You might check this site out for Jag codes. Oxygen sensors can be a sticky job, they're screwed into exhaust and can literally weld themselves in place. Plus in most cases you need special wrench/socket to get around the sensor. (they can be a real pain)
http://www.obd-codes.com/
293 views
Usually answered in minutes!
×