Cars & Trucks Logo

Related Topics:

r
roger kessler Posted on May 05, 2014

I have a 1998 land rover discovery that sticks on 2000 rpm idle/ changed iac valve/no help-ideas?

My discovery is stuck at 2000 rpm idle. i did chabge the battery and fuel pump recently, could one of these cause this?...we changed the odle air control valve to no sucess...i can't afford to go to a dealer, is there anythings i and my mechanic could try?...thanks-roger kessler

1 Answer

Dan Pope

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 50 Answers
  • Posted on May 18, 2014
Dan Pope
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Nov 17, 2008
Answers
50
Questions
2
Helped
18071
Points
89

Check for a massive vacuum leak

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 24, 2009

SOURCE: 1998 land rover discovery won't start

I just expiriance the same problems on my rover so i check it out and found that the engine spark fuse was out. I replaced the said fuse and their you go it started. You can find that fuse under the dashboard in the satellite 1 fuse box. it should be the 3rd one from the right. Good luck buddy hope that helps you out.

Ad

Anonymous

  • 31 Answers
  • Posted on Mar 20, 2009

SOURCE: radio unlock code for 1998 land rover discovery

Give the dealership your VIN# and they will in turn provide you with an 'unlock' code. Input the code and you should have radio. If not, you will need to remove the radio and give the dealer the chassis # found on the case.

Anonymous

  • 1 Answer
  • Posted on Feb 16, 2010

SOURCE: my land rover discovery is stuck in 4 wheel drive,

The discovery is as previously mentioned permanent four wheel drive.However the difflock/range lever in most suffers from lack of use and siezes all i had to do when i bought mine was plenty of WD40 and patience as i don't think it had been in low range or difflock from the day it was built.don't try to force it just spray it and let it soak then try keep doing this and it should free up if not it may be the selector grubscrew has worked loose just threadlock it and screw it back in.

Anonymous

  • 1 Answer
  • Posted on Apr 12, 2010

SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000

LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP

Anonymous

  • 149 Answers
  • Posted on Apr 13, 2010

SOURCE: 2001 land rover discovery II locate fuel filter and fuel pump

If you're standing looking at the rear of the vehicle, it's on the chassis rail on the right hand side rear wheel arch.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2004 land rover freelander idle air control valve location?

there is 2 valves and are located on the rear of engine on the left has you look from under the hood
0helpful
1answer

I have a 1998 land rover discovery that sticks on 2000 rpm idle/ changed iac valve/no help-ideas?

sound like sticking choke or could be computer settings try dis connecting battery post for a few minutes ground side of battery would be sufficient .
0helpful
1answer

I have a 1999 Range Rover with the Gems 4.0 engine. When I start the engine it goes to around 1800 rpm at idle and will not come of that rpm. What could be the possible causes

There are 2 most probable reasons for a high idle : Vacuum leak and IAC motor (Idle Air Control) is stuck in the wide open position. The vacuum leak could be a broken/cracked or hose that came loose or intake gasket could be leaking. Usually the IAC stuck open will have a code stored, but the best way to test it is with a good scan tool. A cheap (less than $500) scanner will not be able to test it, but any decent shop should have a scan tool capable of controlling the IAC to test it.
0helpful
2answers
2helpful
1answer

What does code p1506 mean?

P1506 - Idle Air Control (IAC) Overspeed Error This DTC is set when the PCM detects engine idle speed that is greater than the desired rpm.
  • IAC circuit short to GND
  • Damaged IAC valve
Disconnect IAC valve and look for little or no change in engine rpm as an indication of a stuck or damaged valve.
3helpful
1answer

Automatic vehicle stalls at low rpm

This is proplem with the IAC valve , try clean the valve and if that doesnt work replace it.

An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body

Thanks
Kindly rate the answer
Smith
24helpful
7answers

WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000

LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP
Not finding what you are looking for?

207 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...