Nothing happens when I turn the key, not even a click. Anyone have suggestions for fixing it? The starter,radio, most of the windows, locks, lights all work. Cruise stopped working a little while ago. Driver's window quit working about a month ago, stuck in down position. I got it back up, then cut wires to window motor, since I needed switch to operate other windows, and didn't want driver's window stuck down again.
Goodness, it sounds like you have too many electrical issues to be able to solve them in a few paragraphs. I would suggest, if you have the time and desire to track this down and fix it, your best bet would be to go get a Chilton's manual for your make and model. It has electrical diagrams and such in the book. It has all kinds of info you may find useful as you worth through your problems.
SOURCE: driver window won't work on 2000 mercury mountaineer
So you wanna take a door apart look at the door look for any liitle plastic caps take them out there may be a screws with cover s aound the sides of the trim or little push ins take them out unscrew them/ take the mirror cover off and thentake the bottom of the panel and pull out ward working your way around to the top/ then opull up and out then take and disconnect the wiring/ proceed to take vaprro barrier off looks like plastic take that off and then you can see the whold outside if you are replacing the motor then you will need to look at where the window should be when you need to take ou the bolts and such/ and thats it then go back ward from here/ Please rate my response Thank you very much
SOURCE: 2000 mercury mountaineer power windows won't work
check for a broken wire in the wiring between the body and door
SOURCE: 2001 Mercury Mountaineer won't start
Have a load test done on the battery. If it checks out good, take a voltmeter to the battery and have an assistant rotate the engine. If you see more than a 2 volt drop when the car is being started, the starter is heading south.
Check fuse 17(15amp) in the interior fuse panel.
SOURCE: Driver window will not roll up, I hear the motor
could be a case of the cable that the motor turns is snaped id say..take off the inside door panel ,shouldnt be to hard ,then activate the switch while looking in,youl soon now exactly what it is,,,,if it is youl need to replace the whole winder including the motor,,get 1 in a breakers yard wont be 2 dear...
146 views
Usually answered in minutes!
The battery is good. I changed key switch and ignition already.
can they be read without the key on?
the OBD reader only require the igntion to be turned on engine not running
I gave up on key switch and put in a push button start switch.
×