1993 Audi 100 Logo

Related Topics:

A
Anonymous Posted on May 04, 2014

Where is brake light switch audi 100s 1993

Is the brake light switch easily replaced?

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Apr 07, 2009

SOURCE: 1994 audi 100s transmission problem, cumputer, no reverse AUDI VW

how too check transmission fluid on audi 100s 1994

Ad

Anonymous

  • 1 Answer
  • Posted on Jul 11, 2009

SOURCE: Audi A4 need to replace rear brake light on audi a4

Inside the boot is a plastic cap embeded in the boot liner. Remove the cap to reveal a screw. Undo the screw and the whole rear light cluster will come away in a sideways and not rearward direction to reveal all of the bulbs. Hope this helps.

airjoc

Rob Sinbad

  • 709 Answers
  • Posted on Aug 26, 2009

SOURCE: Audi 100s 1993 cranks doesn,t start, turns over no

assuming fuse and fuel relay are good, if need them, get them from junk yard for nothing, check if you getting fuel and proper pressure and sparks, by unplugging the fuel line from the filter and point the hose downward away from face and have a friend turn the engine over, no fuel come out of the line, crank sensor or fuel pump faulty, if fuel pump is good than the crank sensor is faulty. crank sensor tell computer to turn on the fuel pump. to check sparks, pull one plug and ground it have a friend turn engine over see if you getting sparks, no sparks, check cap contact,rotor contact and wires, if it looks good, check the coil, make sure you getting power to it and have 12v output, if good, cam sensor is faulty, cam sensor work the same way as crank sensor but tell computer to send sparks to the distributor. Common problems with older european car, crank and cam sensor tend to go bad due to ages and heat abuse.

audi4me

  • 13 Answers
  • Posted on Sep 03, 2009

SOURCE: 1994 audi 100s transmission problem, cumputer, no reverse AUDI VW

Hi I also have an Audi Auto 2.8 non quottro had a simler problom and it turneed out to be one of the gear relays that are under the stering wheel on a left ****** that is.

Anonymous

  • 4793 Answers
  • Posted on Jul 21, 2010

SOURCE: 1994 Audi 100S backup lights (reverse) doesnt work .........

switch on side of gearbox.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ecm module location 1993 Audi 100s

under the passenger side floor panel. Directly below the glove box. Pull the carpeting back from under the dash to access the cover plate.
0helpful
2answers

93 town car got power at brake switch but do not have lites

I had an 89 Thunderbird. Problem seemed to be the brake light switch. Easily replaced by yourself, about $50. from Ford, probably cheaper from an Auto Parts store
0helpful
1answer

I cant seem to find the fuel pump on my 93' Audi 100s

On many (most modern day) autos, the fuel pump is located inside of the tank. This pump is electric and sealed, and the fuel keeps the pump cool during activation. Generally the tank has to be dropped to replace the pump, but see http://forums.audiworld.com/showthread.php?p=24139922
as that pster says there is a way through the trunk.
0helpful
1answer

My 1993 audi 100s won't start, there is no spark.

Check the cam position sensor, on the back of the left valve bank on a V-6 . It's like a round disc, about 2.5 - 3" in diameter with a wire plugged into it. If it goes bad the car won't run, and it can go out suddenly.
0helpful
1answer

I have a 1993 audi 100s and i put power steering fluid in it yesterday and it starts no problem i can drive it doesn't hesitate. But when i go to make a turn it's so hard i literally have to use both hands...

It sounds like you have more than one problem. If the steering wheel is difficult to turn it means the steering pump is not working. Check in the engine compartment and see if the fanbelt is still in place. I think it may have come off since that battery light indicates that the alternator is also not working and both the alternator and power steering pump are belt driven. Post if you have further problems.
0helpful
1answer
2helpful
1answer

How to replace an ignition switch, to a 1993 Audi coupe 2.0

that's easy, remove instument cluster,remove bottom shelf (above brake pedal,) now u have acsess to ignition switch.reach thrue instrument clust. opening on dash,push back ign.plug from switch, use small flat blade scewdriver and remove 2 small screws or loosen them and push out ign.switch (repl. with new one)
0helpful
1answer

LOCATION OF THE HYDROLIC CLUTCH CYLINDER ON A 93 AUDI 100S. THANKS

If you mean the clutch slave cylinder, it is under the dash attached directly to the pedal cluster.. the slave cylinder is located on top of the transmission, accessed from underneath the left front area behind the wheel...
2helpful
1answer

1994 audi 100s transmission problem, cumputer, no reverse AUDI VW

how too check transmission fluid on audi 100s 1994
0helpful
1answer

Lost keys

A local locksmith can make you a set of keys.Good luck.
Not finding what you are looking for?

61 views

Ask a Question

Usually answered in minutes!

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...