SOURCE: Where is the location of the knock sensor for a 2005 HD 2500 6.0
HAS TWO KNOCK SENSORS they are both under intake in valley of engine. remove intake and will see two black grommets they are under those best to replace both at same time
SOURCE: Drain Engine Coolant in 2005 Chevy Silverado 2500 HD
there is a petcock at the bottom of the rad drain ti from there and use a antifreeze tester to check protection temp
SOURCE: How to replace a Thermastat on a 2003 Chevy
The thermostat is located in the water pump on mostn never Chevy trucks. If you pull the upper fan shroud, you should see the thermostat housing. Remove the radiator hose, then the 2 bolts for the housing. Replace the thermostat, and gasket together.
SOURCE: 2005 chevy 2500 hd diesel no fuel getting to the
I'm not sure which engine you have but it has a fuel supply pump usually mounted under the cab on the frame rail, it has a injector pump and an injector pump control module mounted on the engine and the injector pump has a fuel shutoff electric solonoid that shuts the engine off with the key. Provided that there is clean fuel available to the supply pump, any of these 4 parts could cause these symptoms.
SOURCE: How long does it take to replace a power steering
not very long at all. I've been a mechanic for 7 years, and i can have one done in under an hour, that includes removal, installation of the new one, new fluid, and bleeding. The hardest part is removing the pulley. I'm more accustomed to HMMWV power steering pumps, but a 6.6L isn't too far off from those. Let me know if you want a step by step guide on how to do it, i can send instructions direct from Alldata tomorrow from work. Hope this helps.
461 views
Usually answered in minutes!
×