How do i repair trouble code P 0320?
No Crank Reference Signal at PCM No reference signal (crank-shaft position sensor) detected during engine cranking. Use this youtube step-by-step to fix it. How to diagnose P0320 crankshaft position sensor circuit failure
SOURCE: Trouble code 54 on a 1995 Jeep Grand Cherokee
Carb'ed Engines:
Code 54 - Mixture Control (MC) solenoid is shorted or the ECM is faulty.
Fuel Injected Engines:
Code 54 - Camshaft (or distributor sync.) reference circuit - No camshaft position sensor signal detected during engine rotation.
Hope this helps
Mike
SOURCE: 2002 jeep cherokee laredo
the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.
SOURCE: Jeep Grand Cherokee Limited P0700 diagnostic problem
P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.
SOURCE: 96 Jeep Grand Cherokee diagnostic codes P1762 and
governor pressure sensor in transmission is the likely problem
SOURCE: 2004 jeep grand cherokee overland
P0301 is #1 cylinder misfire detected and is most likely related to a worn spark plug that is need of replacement. All plugs should be replaced if replacing one. Not sure how many miles you have on this vehicle, or if plugs were ever installed, but this is the basic step to take in diagnosis.
1,044 views
Usually answered in minutes!
×