The seat belt is stuck, we've tried pulling, yanking, nothing moves! Suggested the mechanism bad and need to replace belt. How do I get to that seat belt?
Please bear with me, a lot of people don't know that if this occurs that you must start the vehicle and relax and pull out the seat belt with a firm and steady action but not to pull too fast or no yanking. You must start the vehicle to reset the security system for the vehicles safety belts to release and go back to ready to use mode
Please bear with me, a lot of people don't know that if this occurs that you must start the vehicle and relax and pull out the seat belt with a firm and steady action but not to pull too fast or no yanking. You must start the vehicle to reset the security system for the vehicles safety belts to release and go back to ready to use mode
×
SOURCE: Drivers electic seat will not adjust
I just had the same problem. When the seat is powered all the forward, one of the worm drives reached the end of its travel and jammed against the threaded block that it passes through. To fix this the seat has to be unbolted and tipped back. There are four tiny 6mm bolts that hold the motor plate in. Remove these and the motor will come out. The worm drive is bolted in at one end and has a set pin at the other. Remove the worm drive and use a couple of vice grips or equivalent to loosen the threaded block from the worm drive.
SOURCE: The front driver seat on 2004 Camry is stuck
Perhaps an item got caught under the seat and possibly affected the linkage wire between rail tracks.A small linkage wire trips the console side track.Without this,that particular track will not disengage.Look under the good working passenger side seat and you might notice this linkage wire.It will then give you an opportunity to see if it works well on the inop seat. You can pull that wire(or trip that linkage arm by hand if you are in a dilemma and need the seat moved in order to drive but use caution on these moving parts and dont get pinched.
SOURCE: can't reinstall 3rd row seat 98 toyota sienna
These seats are hard to get in and out, especially if the receiver hook on the floor has any obstruction; so first thing is to clear out anything that may be interfering with the seat from properly seating in the front hooks.
This fix applies to seats that are stuck and won't come out as well as seats that won't go back in.
Each seat has two levers on their back, marked; one for 'tumble' and the other for remove. Problem is, if you press the 'tumble' lever when the seat is out it may not let you replace the seat without first holding BOTH levers up while pushing the seat back into place, then pushing the seat DOWNWARD to reset the mechanism for tumble. Then, push the seat down so that the locking mechanism for tumble (a black lever under and on the drivers side of the seat).
If the receiver hooks are clear and the seat retainer mechanism is properly set you will be able to push the seat in and press down on the back of the seat and hear a very satisfying thunk that lets you know the seat is properly locked in.
These seats can handle quite a bit of shoving and jamming, and you may just have to work it hard to get them back into place.
SOURCE: driver side seat belt retractor broke. how to fix?
yes you can. I suggest you go to the scrapyard and purchase one there. they are easy to replace and inexpensive.
216 views
Usually answered in minutes!
×