SOURCE: 2005 Crown Vic Police Interceptor: Starts then stalls
Have you checked the fuel filter. Fuel pump will pressure up, but fuel filter could be clogged and not work without the pressure of the fuel pump.
SOURCE: 1998 crown vic police. Had check engine light with
your egr on that side is dirty try cleaning it aslo check intake boltsaround those clyinders.
SOURCE: 1993 crown vic horn/cruise control won't work
Check the fuse for your cigar lighter/horn. I've seen the fuse blown from the lighter shorting. It will caue the cruie not to work also. I hope this helps. Good luck.
SOURCE: 1999 ford crown vic dash light running light problem.
Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally
Testimonial: "thank you for quick response will try all of your suggestions will re post if no luck."
SOURCE: 97 Crown Vic transmission issue
Check the transmission linkage cable that runs from the steering column under the dash to the trans under the car. make sure that the cable is not damaged and that all connections are tight.
Hello
When the service engine
soon light (Also called the check engine light) is turned on this is
to alert you to the fact that Powertrain Control Module (computer)
has detected a failure somewhere in the systems it controls you may
not feel any difference in the way the engine runs, this can be the
transmission or the engine or emission system, there are fault codes
set in the modules memory for these faults. What needs to happen now
is to have the powertrain control module scanned with a special tool
called an OBD2 electronic engine control scanner or a OBD2 code
reader. Once the code(s) are read then you must perform the
diagnostics for each code and make the appropriate repairs based on
the findings of the diagnosis that was performed, this is called
doing "Pinpoint" testing.
25 views
Usually answered in minutes!
×