Where is the hazard flasher located on 1996 Infiniti G20?

located under the dash by the steering colume , if you put the signal light on then look under the dash you will be able to find this flasher but hearing and feeling which flasher is making the noise. then look for another flasher that looks the same this will be the hazard flasher.

the hazard flasher is a separate flasher from the signal flasher.they are located on the fuse panel under the dash on the drivers side.some are held in a clip to the wiring harness under the dash.you don`t say if one or the other is working if so then turn on the one that works and look for it and you will see what they look like and find the other and change it.

Try below the steering column under the dash area.
1996-00 Vehicles Fig. 3: Turn/hazard flasher location - 1996-00 vehicles
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located on a bracket above the brake pedal. Replace the flasher by unplugging the old one, removing it from the bracket, and plugging in the new one.

a turn signal flasher/hazard relay controls that. it is probably defective. replace with new reliable one to fix problem. it's usually round

For 1996 Chevrolet Cavalier 2.2L SFI OHV 4cyl, the Flasher is located front seating area, driver side, under dash, above kick panel, mounted in bottom of convenience panel.



Fig.: Turn/hazard flasher location-1996-00 vehicles

Hope helps with this (remember rated this help) TY for using Fixya.

there are two flasher for this car, one for the hazards and one for the turn signals, the turn signal flasher is located behind the center of the ashtray,the hazard light flasher is located on the fusebox center.this fuse center is located behind the right side of the dash to the right of the glove box, hope this helps.

FIRST Check for Blown Fuse Then Locate Flasher Units @ Fuse Block to Determine Wiitch one is Hazard Turn On Key Then Turn Syg. Feel Flashers The One you feel Clicking is For Turn The Other IS Flasher Replace this Flasher unit.

1. Verify the customer's concern by operating the turn signal/hazard flasher lamp to duplicate the condition.
2. Inspect to determine if one of the electrical concerns apply: VISUAL INSPECTION CHART Electrical

• Circuitry open/shorted.
• Fuse junction panel Fuse:

+ 15 (10 A) + 29 (15 A)

• Damaged multi-function switch.
• Miniature bulb burned out.
• Damaged lamp.

1. If the inspection reveals obvious concern(s) that can be readily identified, service as required.
2. If the concern(s) remains after the inspection, determine the symptom(s) and go to the Symptom Chart. See: ProceduresSymptom Chart(s)

1. Access the COMBINATION Turn Signal and Hazard INDICATOR FLASHER on the Left-Hand (drivers) side of the instrument panel in the fuse junction panel.
   

1. Remove turn signal flasher/hazard indicator flasher by pulling indicator flasher straight out.
   

1. To install, align the terminals of the flasher and press into place.
   

How about a picture--

what is it that you have to change your flasher? have you check the fuses that may fix your problem. now your flasher location is under your sterring colum by the fuse box