Jaguar XK8 sill trim removal - 1999 Jaguar XK8

Question edited for clarity, add maker and toss in some CAPS.
Question moved to model category.

99 XK8 Stereo Wiring Diagram

Jaguar Forums https://www.jaguarforums.com > xk8-xkr-x100-17

Nov 23, 2010 - I have seen multiple wiring diagrams throughout the site but none specifically for a 1999 XK8 Convertible Stereo with premium sound (Harmon ...

wiring diagram harman kardon amp - Jaguar Forums
Apr 17, 2014
My first Jaguar XK8 Convertible stereo headunit
Dec 16, 2016
2000 XJR Radio Wiring Diagram - Jaguar Forums
Oct 22, 2010
Pin Connections Required for Harmon Kardon Rear Speaker ...
Nov 16, 2017
More results from www.jaguarforums.com Missing: Harman ‎' Show results with: Harman

1999 Jaguar XK8 Car Stereo Wire Colors and Locations

the12volt.com https://www.the12volt.com > installbay > stereodetail
1999 Jaguar XK8 Stereo Wiring ; Ground, Chassis ; Illumination, n/a ; Dimmer, n/a ; Front Speakers, 5 1/4" Doors.

The only place for routing would be on a dealer bulletin. You can get from www.alldata.com

..

Ck here, there's one you canprint off for the glove box.
3d post down I believe...

https://www.jaguarforums.com/forum/xk8-xkr-x100-17/fuse-chart-98-xk8-112762/

Best to you

I'm having a similar issue to the one described in this post:

http://www.2carpros.com/questions/jaguar-xj8-1998-jaguar-xj8-car-turns-over-then-stalls

However, I can not find an inertia switch. I have a 1998 Jaguar XK8 convertible. Does being a convertible make a difference in this switch's location?
I removed the passenger kick panel and also checked in the fuse box door on the dash at the passenger side. Thank you.

Remove the door opening weather-strip. Refer to Door Opening Weatherstrip Replacement in Doors.
Remove side sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
Remove the lower quarter panel trim. Refer to Rear Quarter Trim Panel Replacement in Interior Trim.
Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement in Interior Trim.
Remove the quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement in Interior Trim.
Remove the center pillar outer applique. Refer to Center Pillar Applique Replacement in Exterior Trim.
Remove the roof drip molding. Refer to Body Side Roof Drip Molding Replacement in Exterior Trim.

Important: It is necessary to use new nuts when reinstalling the quarter window.
Remove the nine quarter window nuts (1), securing the quarter window assembly (2) to the body opening.
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
Important: When removing the quarter window from the body opening make sure that the attaching pins are clear of the outer body.
Remove the quarter window (2) from the body opening.

Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Remove the rear seat back. Refer to Rear Seat Back Replacement in Seats.
Remove the door sill plate. Refer to Door Sill Plate Replacement .

Remove the 3 quarter trim panel retaining screws (1).
Starting at the lower edge of the trim panel and moving alternately clockwise and counterclockwise, pull outward on the trim panel to disengage the eight rear quarter trim panel attaching clips (2).
Remove the quarter trim panel from the vehicle.
Remove the 4 radio speaker grille speed clips (1), securing the speaker grille.
Remove the speaker grille (2).
Remove the rear quarter trim panel insulator (1), from the back of the quarter trim assembly (2).
Remove 7 rear quarter trim panel armrest retaining clips (1).
Remove 7 rear quarter trim panel armrest retaining nuts (2).
Gently pry the quarter trim panel armrest insert assembly (3), away from the rear quarter trim panel and remove.

You mite look for a video on youtube !

It is located behind the right rear quarter panel , In the back right of the interior !
Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side in Interior Trim.
Removal Procedure

1. Remove the rear seat. Refer to Rear Number 2 Seat Replacement or Rear Number 2 50-50 Seat Replacement in Seats.
2. Remove the Third Pillar trim panel. Refer to Third Pillar Trim Replacement .
3. Remove the garnish molding. Refer to Body Rear Corner Garnish Molding Replacement .
4. Remove the door sill plate. Refer to Liftgate Door Sill Plate Replacement .
5. Remove the quarter panel trim screws.

A lot involved in this but not to difficult !

1. Remove the rear door sill trim plate. Refer to Front Side Door Sill Plate Replacement or to Rear Side Door Sill Plate Replacement .
2. Remove the lower rear seat belt cover and bolt.
3. Remove the trim panel from the vehicle.

Remove the sill plate. Firmly pull the sill plate up and out from the retainers.
Remove the sill plate from the vehicle. Start from the front of the door sill. Use a flat-bladed tool in order to pry the door sill plate.
Rear Side Door Sill Trim Plate Replacement
Use a flat-bladed tool in order to pry the door sill plate. Remove the sill plate from the vehicle.
Body Rear Corner Garnish Molding Replacement
Remove the rear upper garnish molding. Refer to Rear Upper Garnish Molding Replacement .
Pull down on the upper corners of the garnish molding in order to disengage the retaining clips. Pull in order to disengage the remaining retaining clips. Remove the rear corner garnish molding from the vehicle. Inspect the rear corner garnish molding for broken or missing retaining clips. Replace the retaining clips as needed.
Good Luck ! Fun job !!!!!

REMOVE ANY TRIM, CENTER NUT, AND RENT A STEERING WHEEL PULLER AT AUTOZONE....PULL WHEEL

http://www.car-stuff.com/mmparts/jaguar-xk8/acc_cabin_filter.html bout half way down the page you will find the 98 xk8 ACC Cabin Filter

Hi

1. Remove the black trim panel holding the cruise control and sport mode buttons from around the shifter. There are 4 clips holding the panel on: upper left, lower left upper right and lower right. Be careful, they break easily. Remove the wires from the buttons.
2. There are two brackets holding the wood panel down, one on each side of the shifter. Remove the two screws holding down each bracket. Be sure you note the orientation of the brackets - it will make reinstallation easier. Lift off the wood trim panel.
3. Under the wood trim you just removed, there are four bolts fastening the console to the car. Remove them.
4. Open the console lid. Remove the two screws fastening the latch strike plate. Again, make note of the positioning of the latch plate for reinstallation
5. Remove any other screws retaining the console compartment. Lift out the compartment liner. Close the console lid.
6. At the rear of the console is a trim cover. It is held by two tension clips. Just pull it off.
7. There are two bolts under the rear trim cover - remove them.
8. Remove the console.
9. Remove the screws holding the radio in the dashboard and pull the radio forward.
10. Remove the antenna wire and wiring harness connectors from the back of the radio.
11. Unbolt the ground wire from the back of the radio.

Reinstall in reverse order.


Let us know if you have something more to know else accept the suggestion.
Thank You for contacting Fixya.com

Drivers side. Pull back the trim inside the door handle pocket, uner the trim there is a philips screw, then the window switch with wood trim pops out, disconnect the connector, swop the sprung wood trim and your good to go.

hı thıs ıs cıhan pekın ıhave xk8 1997 ı m lookıng complate soft top for my car because mıne was broke ın that case ı can sent your neeeded parts ı u wısh also could you help me for used complate soft top (blue)my best regarts