How to Reset Computer On 1996 Dodge Van ? - 1995 Saab 900

1996 Dodge Ram 3500 diesel Standard Payload, lbs.ext. cab long bed 5151, ext. cab short bed 3915, reg. cab long bed 5340, reg. cab short bed 2372.---------------------------------------------------------------------------------------
Multi-Di@g Access J2534

There are no child anchors on a 96. This was around the time the latch system was under development. Just went through looking into this for my 1996 van. chico car seat fit well

The newer van seats will not fit either( I do have a 2007 seat for sale now ) as I tried to make one fit in my 1996 van with the latch system and it didnt fit. Wheels right spacing too wide for the anchor points.
Tom K. MN

I’m happy to help further over the phone at https://www.6ya.com/expert/james_da451a4ec470352a

Many things can cause this, you need to pull the error codes to find the most likely cause.

Turn van off. tuen key on-off-on-off-on (do not go to start or acc position)

I'm assuming you have the digital odometer.
Watch the odometer for Pxxxx codes and write them down.
Post whatever codes you get, and we'll be able to tell you what the van computer is or isn't seeing that causes it not to fire the spark plugs.

Distributor Ignition Pickup. starter switch , computer

Note this information, about Dodge RAM 1500 have 3.9 engine... 1996 Dodge 1500 Pickup 3.9 liter V-6 VIN "X"




This is for one 3.8L V6 1996 Dodge 3.8 liter V-6 VIN "L"




Hope helps (remember rated this).

I don't beleive so, the 95 is OBD I and the 96 is OBD II. Plus you'll need to verify the exact transmission according to engine and 4X4 or 4X2.

If you don't have power to the coil you probably have a bad ignition module. And what reset button are you looking for?

Adjust your timing and plug the thing in to check for fault codes.

Check all of your dash fuses inside the glove box if these are fine. Remove the door panel nd check to see that the wires have not come loose they tendto come loose from closing the rear door.

What engine ?