I have a land roover 2006 sports but u have a problem yesterday i see this baterry loose and then i remove terminal and i clean positive side and then i pix and tight but now no starting engine power

question edited for clarity and toss in some CAPS.
Question moved to model category.

Camshaft Position Sensor Location

Range Rovers Forum https://www.rangerovers.net > threads > camshaft-posit...
Nov 5, 2021 - It's right under the VVT solenoid on the upper timing cover. 2 per cylinder head, 4 per car. Part LR014372, however a Bremi 31491073 is the same ...

Which is bank one? - Range Rovers Forum
Jun 14, 2016
Can the Cranck Position Sensor be installed DIY ? What to do
May 27, 2015
Not Starting, but cranking - Range Rovers Forum
Oct 22, 2016
Crankshaft sensor ' Range Rovers Forum
Apr 13, 2007
More results from www.rangerovers.net

check out the video

https://www.google.com/search?q=2006+Land+Rover+Sport+so+I+can+hook+up+a+pigtail+for+trailer+lights

and also

https://www.google.com/search?q=2006+range+rover+sport+trailer+wiring+harness

..

Do NOT delay in getting this checked. It may be something simple, but it could also be potentially dangerous. See the articles on the website www.graemecooper.com.au about identifying noises

when the battery terminals are removed this tends to corrupt the CPU program . Use a scanner to reset the CPU program and the problem should be solved.

Removing the battery on these vehicles often results in an "arming" of the alarm system and needs to be reset by a dealer or a shop with qualified equipment. You can try disconnecting the battery for 10 minutes, hooking it back up and using the key fob to lock and unlock the vehicle before trying to start it. If the vehicle does not crank after the above procedure, then fault codes may need to be cleared and/or programming may need to be carried out.

the cable /fuse to alternator has nothing to do with the start and run function if the battery is charged up and in good condition ,sounds like the main battery cables have a bad contact/connection or battery is shot<follow battery cables and remove all points of connection in engine bay area clean contacts with sandpaper and resecure all connections 1 AT A TIME! to make sure none are swapped around by mistake ) on both earth cable/negative and the positive/power cables,make sure terminals on battery are clean and tight , try boosting/jump starting your battery with jumper cables connected from another cars battery positive to positive .........negative to negative and see if it starts ,i doubt the problem of starting up is the alternator unless battery is flat and not being charged by alternator ,by jump starting with another baterry will give you the answer once all baterry cables and connections are clean and secure

Most cars you don't have to remove the entire panel. the side mirror has it's own small panel. It is just clipped on. just pry it off to access the nut to remove the wing.

Remove all guards in the way, unbolt the baterry hold down clamp, remove,then unbolt each battery terminal. replace battery with a fully charged battery of the same type. Clean the terminals good before installing back on the battery. Use thw terminal washers, usually green and red in color, red for the positive post and so on. Rough the posts, smear some battery grease on each post install washers, then battery posts themselves. Tighten both posts just to the point that they will not turn, don't overtighten them they may break, then you'll need new post ends.

put the key into the ignition and turn to position 2 leave it for 10 mins it will charge the battery on the key remote

YOUR BATTERY SAFTEY TERMINAL MOST LIKELY BLEW (ON POSITIVE BATTERY CABLE ON RIGHT SIDE OF TRUNK). NEEDS TO BE REPLACED. SEE A DEALER.