Replacing motor mounts 2007 Chrysler Pacifica 4.0

SOURCE: replace the engine motor mounts and the transmission mount. Would like to know how to do it. Thanks.

Check the frame mounts too. You will have to loosen the bolts and jack the motor up with a jack and a woodblock.

SOURCE: 2007 Chrysler Pacifica Touring Edition 4.0L. Trunk

have your deaker check trunk model and motor

Jeffrey Turcotte

• 8991 Answers
• Posted on Oct 01, 2010

SOURCE: where can I find a

3.5L engine?

chargerhp

• 815 Answers
• Posted on Nov 29, 2011

SOURCE: i need to replace a heater blower motor on a 2004

1. Disconnect and isolate the negative battery cable.
2. Remove the passenger side cowl trim panel. See: Body and Frame\Interior Moulding / Trim\Trim Panel\Service and Repair\Cowl Trim
3. Pull back the carpet to access the front upper screw that secures the air inlet housing.
4. Remove the recirculation door actuator.
5. Remove the recirculation door actuator wire lead from the routing clip located on the lower air inlet housing and position the wire lead aside.
6. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.

1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.

1. Push the rubber blower motor wire lead grommet through the opening in the lower air inlet housing.
2. Feed the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
3. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
4. Gently flex the recirculation air door far down enough to remove the blower motor and wheel from the HVAC housing.

1. Remove the blower motor and wheel from the HVAC housing. Note the position of the blower motor mounting tabs.

1. Position the blower motor and wheel to the lower half of the HVAC housing. Align the blower motor mounting tabs to the correct location on the HVAC housing.
2. Gently flex the recirculation-air door far down enough to install the blower motor and

chargerhp

• 815 Answers
• Posted on Dec 21, 2011

SOURCE: change front motor mount 2005 chrysler pacifica

There is not a mount on the front