Location of knock sensor for honda civic - 2000 Honda Civic

The knock sensor on a 2003 Honda CRV is located on the engine block. Specifically, it is located under the intake manifold, which means it can be difficult to access. Here are the steps to locate and replace the knock sensor on a 2003 Honda CRV:

1. Disconnect the negative battery cable to prevent electrical shock.
2. Remove the intake manifold. This involves removing several bolts and electrical connections.
3. Locate the knock sensor, which is located near the rear of the engine block, under the intake manifold.
4. Disconnect the electrical connector from the sensor.
5. Remove the sensor from the engine block. This may require a special tool, depending on the specific design of the sensor.
6. Install the new knock sensor, making sure it is properly aligned and tightened to the correct torque specification.
7. Reconnect the electrical connector to the sensor.
8. Reinstall the intake manifold, making sure all bolts and electrical connections are properly secured.
9. Reconnect the negative battery cable.

Note that if you are not experienced with working on engines or are unsure of how to proceed, it may be best to seek the assistance of a qualified mechanic to replace the knock sensor on your 2003 Honda CRV.

images for Knock sensor location on a 2001 Honda ...

Honda knock sensor p0325 - YouTube

? 6:41
https://www.youtube.com/watch?v=yacSiSJ5Vc0
Feb 17, 2014 - Uploaded by Cody the Car Guy
do you know where is the knock sensor on a 2005 Honda accord coupe .... 2001-2005 Honda Civic Cam ...

Civic knock sensor - YouTube

? 1:28
https://www.youtube.com/watch?v=D1jk5OxuOB0
Jan 18, 2015 - Uploaded by chriizt1an
96-00 civic ex. ... Civic knock sensor ... 2001-2005 Honda CivicCam Position Sensor TDC Sensor & Valve ...

Honda Civic Knock Sensors - AutoZone

have you had the OBD codes read ? if the knock sensor is faulty follow this link to a honda owners forum which should help

Knocking is produced due to the following reasons:
- Contaminated fuel.
- Restricted or purged fuel line.
- Fuel pump pressure too high.
- Clogged Fuel Injectors.
- Ignition timing too early.
- Wrong heat range and air gaps of the spark plugs.
- Excessive carbon accumulation in the combustion chamber.
- Knock sensor.
- Brake system.

If you mean a knock sensor, I doubt it.

Check your knock Sensor and cam shuft sensor.

It is on the lower left side of the engine (side towards firewall - see picture).
Knock sensor failures are pretty rare, why are you looking for it?

p0325 is referring to the knock sensor. normally it's not the sensor itself but the wiring, connector, or the signal is missing. the sensor might be bad. here's a honda forum thread that discusses knock sensors.

What sensor are you try to look for?
here is the list of all the sensors for 97 honda civic EX
1.Countershaft Speed sensor
Driven Pulley speed sensor
Engine Coolant Temperature Sensor
Front wheel sensor
Fuel Tank Pressure Sensor
Intake Air Temperature Sensor
Knock Sensor
Mainshaft speed sensor
Manifold Absolute pressure (Map) sensor
Primary Heated Oxygen sensor
Rear Wheel sensor
Secondary Gear shaft speed sensor
Throttle Position sensor
Vehicle speed sensor.

I hope this can help you, please put something on the ratting. good luck.

It is located Under hood, center, rear engine area, below intake manifold, mounted in engine block . Simple to replace unplug unscrew. install reverse of removal.