Bought new battery for 2 keyless remotes.neither one would work even after replacing batteries
SOURCE: programing keyless remote
To Program a new remote you must get in your vehicle, close all doors hold your unlock button down.while holding the button down turn your key on and off two times.at that time your locks will all cycle.Then with your keyless remote hold your lock and unlock buttons till the locks cycle .
SOURCE: Keyless remote entry does not function, panic button does.
This link will take you to very good instructions try it worked for me www.wikihow/program-a-keyless-entry-for-a-chevy-silverado this works on GMC models also.
SOURCE: Driver 2 Remote Keyless Entry (RKE) not working, Driver 1 is OK
To resynchronize your transmitter, stand close to your vehicle and press and hold the LOCK and UNLOCK buttons on the transmitter at the same time for seven seconds. The door locks should cycle to confirm synchronization. If the locks do not cycle, see your dealer for service. I hope this works and good luck
SOURCE: Keyless remote Problem for Yukon Denali 2005
Have your dealership test the remotes for you, they will also use a "Tech-2" to re-program it and should not charge you to do so. "I know mine does not" The "puddle" lamps come on when you un-lock the doors with the remote."If they are enabled in the options on your dash information center or "DIC". "See owners manual for info on that". As far as the DRL's make sure your bulbs are good because they are known to blow out. But the remote should not have anything to do with those.Hope that helps a little?
SOURCE: keyless entry remote quit working. Just purchased
Transmitter Programming
Notes
Transmitter Programming
39 views
Usually answered in minutes!
×