SOURCE: 1985 monte carlo determination
Check your fuel pressure. For fuel injection, it should be 9-12 p.s.i. Your fuel pump is located in the tank. You might have to install an adapter fitting to hook up a pressure gauge. This can be installed inline at the throttle body or at the fuel filter. The fuel filter is mounted on the inside of the frame rail. You might just remove the fuel filter to see if you can blow through it. If you can't blow through it, it is plugged up and that may be your problem. You will need two wrench sizes to disconnect the filter 20mm and 16mm.
SOURCE: need wiring diagram for 1985
i need the wiring daigram for my power windows on my 1985 monte carlo
SOURCE: 2001 monte carlo ss. Rear wheel bearings making a grinding noise
It is pretty easy, there is not much labor involved if it has anti-lock brakes in the rear you will also have to un-plug the wire harness attached to hubs.
SOURCE: 1998 monte carlo brake lights
I have the same problem,it's the switch inside the turn signal
assembly.Unfortunately the entire assembly switch and all has to be
replaced.
Hope this helps.
SOURCE: 1998 Chevrolet Monte Carlo brake lights do not
I had to replace the turn signal switch in my 1998 z34.Now everything works fine.
130 views
Usually answered in minutes!
×