Is there any trick or tool that could be used to separate the sump from the motor as these models do not have a sump gasket but are stuck together with silicone compound and I am worried that I might damage the sump trying to lever it off as they are firmly stuck together Kind regards Bob T.
SOURCE: 08 toyota sienna van and oil filter change
a local auto parts store will have every thing you need including manuals
SOURCE: 1979 Toyota Hilux alternator wiring
always, counterclockwise starting with blue, then yellow, then red
SOURCE: How to reset timing belt light
to reset the light you need to remove speedo dash assembly ,on the back of the printed curcuit there is a small screw and a hole next to it remove screw and fit to empty hole . refit assembly
SOURCE: I can't find the fuse box for the electric
there are three fusebox locations. under the bonnet, in on of the kick pannels, and behind the glovebox. check them all.
SOURCE: front crankshaft seal, 1989 hilux
Hello,
Yes, it's possible to change the seal after removing the balancer.
If the balancer shows signs of scratching, wear at the place of the seal, change that part too!
To remove the old seal, drill 2 small opposite holes in the seal flange ( there is metal in it ).
Screw 2 (parker) screws in the holes, so you can pull the seal out gently.
Grease the new seals' inner race, and put some sealant paste to the external race.
Push it back in place with a wooden piece ( drill a hole in the center for the crankshaft end )
Grease the outher race of the balancer. This will help the seal come gently into place.
Good luck!
41 views
Usually answered in minutes!
×