SOURCE: replacing a outside door handle on 1995 hyundai accent
Hi
Please follow these steps :
1. Remove the 4 screws and the screw in the opening mechanism.
2. Remove the cap on the lock button.
3. Remove the mirror lever cap by pulling it straigt out. It is attached with one clip.
4. Remove the door crank by detaching the C-clip between the spacer and the door panel. It's tricky and somekind of hook could be useful.
5. Pull out the plastic clips. Be careful. I think a spatula could be a useful tool.
6. Move the panel forward and up to remove the opening mechanism from the door. Then pull the mechaninsm out from the panel, turn it and push it back through the panel.
7. At this point the panel should be removed and you can see the door speaker and the adaptor. As you can see the opening mechanism remains on the door.
To put the doorcrank back just put the pieces together in the picture and push it in position.
Good luck and Do rate the solution as FixYa if found useful.
Thanks
Rylee
SOURCE: change brakes on a 05 hyundai tucson
rear pad replacement is basically the same as front. 14mm bolts holding caliper and mount on hub then the piston just pushes in
SOURCE: Hyundai accent 1997, the driver side door handle broke
taking off the door panel is a lot of work. i can explain it all to you if you still have the same problem. i've replaced all of my door handles for all 4 of my hyundai's doors, so i'm experienced in this department. would you like a step by step walkthrough still?
SOURCE: How do I remove rear rotor from 2005 hyundai
What you have to do is first remove the screws that hold the rotor on to the hub, let off the hand brake shoes(they are located inside the rotors) there is a rubber plug on the face of thr rotor, take that off and loosen the hand brake adjuster! remove the brake caliper and caliper carrier and the rotor should come off! hope this helps
SOURCE: headlight aiming
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
812 views
Usually answered in minutes!
×