Change turn signal light bulb - 1985 Chevrolet Camaro

That happened in my 1999 Buicke Century. Replaced the bulb 4 times kept burning out all within a week. Finally replaced the blinker socket and no more issues.

Lamp, bulb, supply and ground obviously ok as the hazards work - I suspect the hazard switch might be faulty or something like a dodgy multiway connector onto the switch...

Change the license tag light bulb.
Change the left turn signal light bulb.
Change the headlight bulb.

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Instructions
1Start your vehicle's engine. Turn the steering wheel the opposite direction of the bulb you need to change. If you need to change the left turn signal light bulb then you will turn the wheel as far as you can to the right. This moves the wheel out of the way so that you have access to the fender and the turn signal assembly.


2Get down by the front fender of your vehicle. Use a Philips screwdriver to remove the screws from the wheel well cover. Take off the wheel well cover and set it off to the side.




3Stick your hand into the wheel well and find the turn signal bulb. Turn it to the left and unscrew it from the turn signal assembly. Remove the bulb.


4Take your new turn signal light bulb and screw it into place using your hand. Replace the wheel well cover and use the Philips screwdriver to secure it in place. Repeat this process for the turn signal on the other side of the vehicle.

Read more: Chinasinoy

Usually a problem with the turn signal switch.

hello,

Identify the blown bulb. Note that if a headlight bulb has blown, the dip beam is on the outside and the high beam is on the inside. Turn off the ignition switch and light switches.

Open the hood and replace any blown headlight bulbs. Press the plastic spring clips and remove the bulb holder from the assembly. Pull the bulb out of the bulb holder and replace it with a new bulb. It only fits one way. Be sure not to touch the bulb's glass. Replace any parking lights at the same time, they are in the headlamp unit too.

Remove the front turn signal light unit in the bumper to change the turn signal bulb. Push gently on the inside edge and insert a blade between the bumper and the lens at the outside edge. Compress the spring and remove the lens. Fit a new lamp by inserting it into the plug. The side marker light is changed using a similar process.

Open the trunk to replace the rear fog light, stop light, tail light, reversing light and turn signal light. Remove the rear light cover and turn the bulb holder fastener 90 degrees counter clockwise. Remove the expired bulb, fit a new one and replace the parts, turning the bulb holder clockwise.

Thanks..

This may have more then one bulb in the front or possibly a bad socket try wiggling the new bulb in the socket to see if it will work.Compare all turn signal lights that come on the passenger side to those drivers side.Some vehicles also incorporate sidemarker lights with the turn signals.