Vsc light reset - 2007 Lexus RX 350 FWD

Is you vsc light on by itself, or is it on with a Check Engine Light as well. If it is just the VSC light then you need a Zero-Point calibration. This is supposed to be only done at a toyota/lexus dealer. They take out the VSC computer and run their diagnostics program and reset and configure(calibrate) your vehicles VSC. I personally would disconnect both battery terminals for at least an hour, even better overnight, this should allow enough time to have all the electricity drain completely from those computers. Hopefully this would reset everything. I would try this before going to the dealer, try to save some money. If it is the VSC and CEL(Check Engine Light), then you would have to get the codes read at AutoZone....they do this for free unlike the dealer and then post your codes up on this forum. Hope this helps.

Hi, have you scanned the vehicle to see why your check engine light is on? IF no, you need to. Toyota/Lexus computer system illumniates both engine light and VSC lights whenver a fault occurs in either unit. VSC or stability control is like trac-control or ABS braking system. Get car scanned and make sure all computers are scanned for additional codes, repair them first reset lights and test drive. ON a side note, fixing check engine light will usually take VSC light away also, however sometimes the VSC system will glitch out and a Steering Angle relearn is necessary, it takes about 3mins to perform and a good quality scan tool with 2004 current software. Good Luck.

Strange that they didn't reset the CEL/VSC lights for you. My understanding is that it should clear over time, so it sounds like you may still have an issue that's triggering the light. The most common cause that I have heard is the vacuum hose to the air filter box being left off (or knocked off). You might want to ask a local auto parts stores to read the codes and reset the DTC. Many will do this for free (at least many of the large national chains will). If they reset the code, and the problem has not been resolved, the VSC light will come back on. Hopefully it's just the vacuum hose that attaches to the air filter box.

I'm not sure about the Lexus, but Nissan and other vehicles with the VSC usually will be on until you can drive on a straight road for approximately 2-3 miles without stops and about the same speed during the reset process. The interstate or some type of hwy will reset this light once the vehicle has learned the Vehicle Stabilization Control in which is learned by the way you drive and enables the car to have stable control. Hope this helps out, if this doesn't work, I would take it in for more diagnostics.

VSC - Vehicle stability control.

Can not be reset, will have to take it in for service, vsc pick up a code on your system, have it checked out soon.

vsc shuts down any time check engine light comes on. repair engine light problem, reset computer monitoring system and vsc light will go off. must scan computer to pull codes for check engine light and go from there.

how to solve the problem of p0031

go to auto zone, advanced autoparts, or a certified mechanic and ask if they can reset the codes, it should be free

you need to have the computer reset.

vsc light tells that there is something wrong and vsc system is inactive. I got this light last week and went to jiffylube who connected the computer and pulled the error code. Then reset the light and its fine since then.

i would suggest you to go to some auto repair/service shop and get the problem code. and get is fixed and also get the warning light reset.