1992 Jaguar XJ6 Logo

Related Topics:

A
Anonymous Posted on Apr 16, 2014

Reset check engine light on 1992 jaguar xj6 - 1992 Jaguar XJ6

4 Related Answers

Anonymous

  • 1 Answer
  • Posted on Nov 05, 2008

SOURCE: 1996 Jaguar xj6

my 1995 xj6 jaguar windshield wiper don't work, cannot locate the fuse for the wiper, as i do not have the owner manual to see which is the fuse for the wiper in the fuse box

Ad

Anonymous

  • 57 Answers
  • Posted on Oct 28, 2009

SOURCE: 95 jaguar xj6 no brake or reverse lights

Hi the Jaguar XJ6 works off a 12volt, negative earth.... Jauguar are a legend for electrical faults.... ok you need to do a voltage check/fault check on the system, remove the fuses from the associated problems, i.e the rear lights! place a volt metre over the contacts and there should be no voltage present! grab the wiring harness and move it side to side! if you see a rise in the volt metre then there is a short to the earth! this can be done through out the systen including switches.... i would personally check the earth contacts near he problem areas these corrode and you then get a short in the cicuit

Hope this helps.

Anonymous

  • 5 Answers
  • Posted on Apr 14, 2010

SOURCE: Check engine light VCM code "FUEL 14"?

my manual says fuel fail 14 deals with yourr coolant temperature sensor is no in operating range

brian soufane

  • 693 Answers
  • Posted on Oct 17, 2011

SOURCE: how do you clear check engine light on 94 jaguar

First off, you might need to actually have your engine checked. However, if you know that the engine is in good shape and you're still seeing that pesky check engine light in your Jaguar XJ6, here's a cool trick for how to turn it off.

  • Remove the passenger's side dash liner.

  • Look for the round red connector with a single pink/red wire that is hanging free.

  • Turn on the ignition but do not start the car and then press the VCM button.

  • When the code displays, use a jumper wire to short the pink/red wire to ground for 3 seconds.

  • Turn the key off for 10 seconds and then turn it back on and check for any more stored codes.

  • If there are more use the same procedure to clear them.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

The instrument panel light remains on when the engine is shut off and eventually the battery dies.

they usually stay on if your side lights are left on, check your connections on your light switch.
1helpful
1answer

How do I reset the computer on 1988 xj6 jaguar

TO RESET ECM ON A 1988 XJ6 JAGUAR.YOU DISCONNECT NEGATIVE BATTERY CABLE FOR 30 SECONDS TO CLEAR CODE.THIS WONT DO ANY GOOD IF YOU HAVE A ECM TROUBLE CODE DONT FIX PROBLEM.CHECK ENGINE LIGHT WILL STAY ON, UNTIL YOU FIX FAULTY COMPONENT OR SENSOR.
0helpful
2answers

My 1985 Jaguar XJ6 was in an accident. Where is reset button to restart

i need a diagram of a series 11 xj6 jaguar door i.e. the position of the electric window into the door as i cant line the bolts and frame up. need to see a picture of it. thanks
0helpful
2answers

1996 jaguar xj6 dtc test code p1178

Fault code P1178Rich Fuelling Trim, Long Term (AMFR)Check for manifold air leaks, rectify as necessary Check for recorded MAFS fault code, rectify as necessary Clear fault code and perform service drive cycle to verify fault cleared Contact Jaguar Service Hotline if fault still present.

Taken from the Jag service manual.
0helpful
1answer

What does the check engine light vcm code "fuel 14 /fail 14" mean on my jaguar xj6?

this has to do with the engines ability to warm up and meter the fuel. either the thermostat is sticking or the coolant temp sensor is out of range. there are 2 of them at least, one for the guage and one for the pcm. if you find it is the t-stat sticking, replace with jaguar parts.
1helpful
2answers

Check engine light VCM code "FUEL 14"?

my manual says fuel fail 14 deals with yourr coolant temperature sensor is no in operating range
0helpful
3answers
0helpful
1answer

Hi 1995 xj6 sport,no speedo,and antilock light on soon as engine started.abs and wiring seems ok is there a reset for this??????????????help

Seems that your speed sensor (mounted on the differential housing) has a defect. See Haynes how to check it.
0helpful
3answers

1996 Jaguar xj6

Many cars of that period could be reset by some ignition key sequence.
Try switching from the off position to the on (not start) several times within 15-30 seconds.
It won't hurt anything and might turn off the light.
If the problem is still present that caused the light to go on the first time, it will likely come on again after you start the engine.

I hope the reason for that alarm light has been since corrected.

Some cars needed to have the battery disconnected for several minutes to cancel the memory contents.
Newer cars will not likely respnd to that since flash memory is now common which retains the error code even without power.
Not finding what you are looking for?

175 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...