2001 windstar im getting codes po172 po174 po301 po302 po 303 po304 po300 installed new coil pack twice new wires,plugs,cam and crank sensors,fuel andair filters,pcv valve and now get these codes. engine shut down in heavy rain storm did all this and still getting codes.runs rough could it be water in fuel.

Do tune up,coils module,wires,plugs and see what happened..

PO300 and P1399 are random cylinder misfire detected.
PO301 cylinder 1 misfire
PO302 cylinder 2 misfire
PO304 cylinder 4 misfire
PO306 cylinder 6 misfire
I would say that you have damage to the ignition wiring harness or you ECM is failing.

code p0102 refers to MAF/VAF sensor ---low input ===causes --wiring short to ground. MAF/VAF sensor
code po172 refers to system too rich --bank 1=== causes ---intake blocked --EVAP canister purge valve---fuel pressure ---HO2S sensor
code po random misfires ---plugs --wiring ---injectors--low compression
code po305 refers to cylinder 5 misfire detected ===causes --engine mechanical fault--ignition/ fuel system ---injector ---ECT/MAF

I would check that the air filter is not blocked first as it affects the MAF/VAF sensors . Have a fuel pressure system pressure test done

All cyls misfiring. 97 honda. How many miles?Sounds like plug wires or a wet distributor cap. Yet if it is a Vtec The misfires could be occurring after the cams engage. Possible VTEC solenoid issue.

Which code you have po300 or po301.po302 .PO301,PO302 will be coil or module.PO300 could be bad spark plugs,vac. leak,clog fuel filter,bad fuel pump,bad battery.

PO 300 is multiple misfires detected
PO 301, 304, 305, 306 are misfires in cylinders 1,4,5,&6
PO 053 is HO2S Bank 1 Sensor 1 Heater Resistance
PO 106 is MAP/BARO CKT Range / Perf
PO 316 is Misfire detected 1st 1000 Revs.

On a misfire, I usually push towards the spark plugs, plug wires, and coil packs / distributor coil.
You have PO 106 and PO 053 that need to be inquired about at nearest AutoZone.
They can give you an idea as to what is the problem on these.

Did a MAP sensor **** out and cause all the misfires ?
Did a misfire cause the MAP sensor error?
You see what I'm saying ?...Something caused all the misfires...thinking MAP...but not that familiar with the function of the MAP.

Hope this helps...

I think that PO422 is the Cat Converter, it may be bad or may be just the O2 sensor.
The PO300, 302, 303, 304 code have to do with the ignition coils or wires. (302, 303, 304 means there are ignition /firing problems in cylinders 2, 3and 4). If your lucky just the wire and new spark plugs.
Google "engine codes Jetta" for more on web. Good luck.

Replace the coil pack.

Replace the coil pack..

Replace the coil packs.
Your issue is NOT the converter, or you would have a P0420/P0430 code