Turn signals work but the brake lights do not how do i get them to work? i already changed the flasher.

Brake lights /rear hazard lights not working - Ford Truck ...

www.ford-trucks.com > ... > 1967 - 1972 F-100 & Larger F-Series Trucks
Jul 9, 2010 - After checking the brake lights I tried the emergency flashers and found that they are working in the front but not in the back. I do have rear turn ... 1995 F350 Brake Lights / Turn Signals not working
Jul 9, 2012
Turn Signals and Brake Lights Do Not Work
Mar 10, 2012
Turn Signal, Brake Lights, & Rear Hazard not working
Aug 3, 2010
Rear Turn Signals, Hazards and Brake Lights not working....
Aug 29, 200

I have to think the problem is inside the turn signal switch, a poor internal connection. You know the brake signal first goes through the turn switch before it goes to the bulbs. That is why the brake lights and rear turn signal lights share the same filament in the bulb, and the same wire going to those lights. The only difference is the turning side light is affected by the turn signal flasher, causing blinking, while the other side- the non turning side-does not go through the flasher relay, but straight to the bulb from the turn signal switch. Change your turn signal switch and I believe you will solve the problem. Let me know, okay?

If you already tried the bulbs, fuses and relays:

There's a switch on your brake pedal arm the controls the brake lights. It may need to be replaced or adjusted.

change the bulb if still out then check and test socket/ground wiring/wire harness for damage

replace your flasher, it controls both turn signal, flashers also brake circuit runs througth.

did you change the flasher relay ? it controls the flashers and the hazard

its likely the turn signal switch (multi function switch) if the hi-mount still works,

You changed the hazard flasher or the turn signal flasher? It has two, one for the hazard and one for the turn signals

Flasher Unit sounds bad... change the flasher, which is in the inboard fuse panel.

the multifunction switch (turn signal switch) is a major cuase of this. your high mount stop lamp wire is run through the switch.