Im having a hard time locating a front bumper cover for my bonne, but gran prixs are plentiful will they interchange?
SOURCE: how do I change the fuel filter for a 2002 pontiac Gran Prix
Release the fuel pressure by loosening the gas cap, raise and support the car on jack stands,squeeze the plastic tabs on the male end of the connector,and pull the connector apart.Some models have 2 tabs,and others have 1 and the fuel line screwed into the other side.Remove filter mounting bolt,unhook tab from frame and remove filter. when you put in the new filter, make sure the arrow is pointing toward front of engine.On the line with plastic tabs, just push on till you hear a click, then pull on it to make sure it's latched.Don't forget to tighten gas cap.
SOURCE: How do replace heater core in 2002 Pontiac Gran Prix
i do believe you have to take the passengers side dash apart behind the glove compartment. go to autozone and get a manual or go to the library and check the chiltons manual. this is not an easy job. how bad is the leak? if its not bad these heater cores are made of all aluminum. i would buy a bottle of that radiator additive and see if that takes care of the problem first. it only cost about 5 bucks a bottle and it may permanantly fix your problem.
SOURCE: how do i remove ignition switch on steering cloumn
disable airbag system. 2. on grand prix, remove steering wheel, and upper and lower steering column shrouds. 3. disengage wire harness straps and remove wire harness. 4. disconnect 2 multifunction switch harness connectors from bulkhead connectors. 5. on grand prix slide pass key off of lock module. 6. remove two ignition and key alarm switch assy. screws. 7. remove ignition and key alarm switch. reverse prsedure to install.
SOURCE: 2008 Pontiac Gran Prix,Radio MP3 line-in/aux-in
The upscale model is the only that i know of that has one. What model do you have?
SOURCE: How do i replace a starter on a 2000 Pontiac gran
The starter is located at the front of the engine at the engine to transmission mounting surface.
Disconnect negative battery cable.
Raise and support the vehicle to give access to underside of engine.
Remove main battery cable from starter solenoid (large cable 13mm nut) and solenoid "S" terminal wire (8mm nut) Both at back of solenoid.
Remove inspection plate, usually 10mm screws, one in front and one up from bottom.
Remove the two 15mm starter mount bolts.
Reverse proceedure to install.
Testimonial: "Thank you so very much. I just saved a bunch of money on my repair bill...and not GEICO !!"
135 views
Usually answered in minutes!
×