The Car has power, battery is charged, just changed spark plugs. Fuel Pump kicks on and is getting fuel from the outlet on the the fuel filter.
Have you checked for spark?
have you pulled a plug after cranking to see if it is wet?
does the engine sound like it is turning over faster than usual?
did it just not start or did it stall. Did this happen after you changed the spark plugs?
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: 1996 mazda mx6 ls cranks but won't start
you may need to run a wire from a keyed ignition source that has power while cranking and running to the fuel pump relay and bypass the pcm to test wether it will run, if it runs put a more permanent wire in place.Not too sure what tests youve done but it seems that fuel is what your focusing on so a quick test is too spray engine start up the intake tube to see if the engine trys to run if it does it eliminates a lot of other potential reasons for a no start condition.Also try squeezing the fuel return line to see if the added pressure will try to make engine run.Could be time to replace fuel pump etc anyway let me know how it goes good luck with it
SOURCE: Do you know where or if a 2000 Mazda 626 has a
Hello, I am going to make a few assumptions here. The vehicle has an electric fuel pump and you replaced it. The vehicle has fuel injection. The engine is actually cranking, just not starting, when you say "car still won't crank". You are getting fire to the spark plugs at the plug ends. You checked the fuel pump for power at the pump. No power, then you back traced the wire to the fuse block and checked the fuse to see if it was blown. If the fuse is good back trace the power to the ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel manifold for pressure. No pressure, check the fuel filter for blockage, or replace it. Fuel pump doesn't run, new replacement pump is defective. There is usually some type of control module for the fuel pump on fuel injected vehicles. Good Luck, RAC
SOURCE: 94 MAZDA MX3 REPLACED FUEL
check the fuel pump relay. it is located under the hood in the fuse box directly in front of the battery
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: 2000 mazda 626 wont start,is turning over,fuel
if you have spark at the plugs you need to check fuel pressure at reed valve on fuel rail,you will need at least 55psi to fire injectors,
There are some possibilities which you will have to check in this case:--
1) First of all check the power and voltage to the battery. With meter it will show exact 12 volt if the battery is charged. If the voltage is less get the battery charged at local auto repair shop. If the battery is internally drained and not getting charged then its time to replace the battery.
2) When you crank the car do you see spark coming at the spark plug? If no then its time to check the spark plugs and coil pack. If the spark plugs are not worn out and looks new then its time to check coil pack. The spark plug gets power to spark from coil pack.
3) The other thing to check in this case is the starter solenoid of the car. If the battery is charged and you start the car then it gives power to the starter to start the car. But if starter is faulty or not connected properly then car will not start.
4) The other thing to check in this case is fuel in the car. If there is fuel in the car then check the blockages in the fuel pump if the fuel pump looks proper then check the fuel filter above the fuel pump.
5) If all the above possibilities mentioned above checked out OK/perfect then it's a electrical issue and the wiring's in the car needs to be checked. The car gets power from the battery to get started. so the wires from battery needs to be checked one by one.
-------------
Thanks. keep updated for any more query.you can rate this solution and show your appreciation.
There are some possibilities which you
will have to check in this case:--
1) First of all check the power and
voltage to the battery. With meter it will show exact 12 volt if the
battery is charged. If the voltage is less get the battery charged at local
auto repair shop. If the battery is internally drained and not getting charged
then its time to replace the battery.
2) When you crank the car do you see
spark coming at the spark plug? If no then its time to check the spark plugs
and coil pack. If the spark plugs are not worn out and looks new then its time
to check coil pack. The spark plug gets power to spark from coil pack.
3) The other thing to check in this case
is the starter solenoid of the car. If the battery is charged and you start the
car then it gives power to the starter to start the car. But if starter is
faulty or not connected properly then car will not start.
4) The other thing to check in this case
is fuel in the car. If there is fuel in the car then check the blockages in the
fuel pump if the fuel pump looks proper then check the fuel filter above the
fuel pump.
5) If all the above possibilities
mentioned above checked out OK/perfect then it's a electrical issue and
the wiring's in the car needs to be checked. The car gets
power from the battery to get started. so the wires from battery needs to be
checked one by one.
Thanks.
keep updated for any more query.you can rate this solution and show your
appreciation.
289 views
Usually answered in minutes!
×