My passanger side tail light wont light up. I replaced the bulbs and it still won't light. It lights up when i brake and turn on my turning signal, so I am unsure on the problem.
Hi, please check the working drivers side bulbs to make sure they are the same any signs number- also look for any signs of bad connection like burnt wires or socket try a good bulb in the passenger hole and see what happens
The tail light circuit is separate from the brake and turn signal circuit. Either the bulb socket has gone bad or a wire has flaked out. Check for voltage at the socket on either pin base when you have your parking lights on. If voltage is present, it is either a worn socket failing to hold the bulb properly, or another bad bulb. If no voltage, determine which wire on the other side is tail light power, and run a new wire across to the side that isn't working and connect it to provide power.
SOURCE: 1993 jeep grand cherokee limited no running lights/tail lights.
Id look at the headlight switch and do some voltage tests to see whats coming out of there. Pay close attention to any wires which look like someone was in there already.People can mess stuff up faster and better than the vehicle can by itself!
SOURCE: the tail lights are out, so the brake lights-Jeep Grand Cherokee
i have a 2002 jeep grand cherokee i had the same problem when i would apply my brakes when the headlights were on my brake lights would go out, i found that my bulbsocket was not making good contact with the socket housing, if you notice when you take off a bulb, look at the light fixture where you unscrewed your breaklight bulb you will notice 3 medal contacts-they should be silver in the socket housing and like a copper on the socket bulb, in the socket housing their should be 2 silver contacts together and 1 by itself the one that looks by itself is making bad contact with the copper one thats by itself on the bulb, what you can do for a quick fix is; get a small piece of low cage wire or a thin piece of metal like copper stick that in to the bottom or top of that metal contact--i did it through the bottom leave the wire or piece of medal sticking out enough for where it can get contact with the bulb (just a little wire is enough to make contact, now screw the bulb on and test it---it will work----i did it to mine, if you need more assistance let me know [email protected]
SOURCE: 1999 Jeep Grand Chreokee no turn signals brake lights tail lights
have you tried replacing the bulbs?
SOURCE: How do I replace the rear brake light bulb on a
Get manual at AUTOZONE!! swampratt200!!AAAEEE!!!!
SOURCE: Tail lights work, but not one brake light when braking at night.
2001 jeep grand cherokee left brake does not work period. I replaced bulb to no avail. the entire tail lamp assembly looked brown as though it heated up. However, the tail light, signal light and back-up lights still work. Please help.
Mike.
1,578 views
Usually answered in minutes!
Have you checked the fuses ?
×