2003 BMW Z4 How do I reset a service indicator

SOURCE: Turning off airbag

all you have to do is open your passenger door and on the dash by the ac, there is a little hole where you can insert your car key and turn in where it will then turn the passenger airbag off. I have never had to remove anything to turn it off, all you have to do is turn in with your key!!!

SOURCE: headlight bulb replacement

bulb, igniter, or module, in order of likelihood and cost.
My bulb was out, so had a bulb put in, but still out. Had an off-duty BMW tech do it.
HOWEVER, if you have the HID Xenon headlight option, you can get shocked to death (yes, death) if you touch the wrong things together.

It's in the owner's manual -- turn wheels in or out, on front inside of wheel well is a cover that has small screws holding it in. The there's a plastic cove that snaps off and, walla, you're at the back of the light. It just twists in and out.

Don't touch the new bulb (particularly if it's a Xenon).

I'd pay to get it done.

SOURCE: I have a BMW Z4 2003 2.5 with the exhaust emission

The Exhaust Emission Light can come on if the car is driven slowly over short distances.It will not happen on cars driven at speed. A short trip of ten miles at over 3000 revs should reset the warning light,although it may not go out for a couple of days after you have tried it . Hope this helps and saves a bill at the local dealer. JK

Radio Code Pro

• 2200 Answers
• Posted on Jul 29, 2009

SOURCE: I have a 2003 BMW X5, how do I reset the service indicator?

Hi,

You can reset your service indicator, as follows:

1. Get in the car, close the door, buckle the seatbelt.
   
2. Push in the clutch pedal and hold it to the floor
   
3. Press the left hand dash button (the one that resets your odometer) and hold it down
   
4. Put the ignition key in the key slot, and turn it gently (very gently) until the dashboard lights come on - the key will not click - if it clicks you've gone too far and you have to start again. Hold the key in this position. In five seconds or so, the dash will display "SIA" and some other characters. Do not proceed until this happens.
   
5. Release the dash button (and only the dashboard button) and then press and hold it again. In another 5 seconds or so the display should begin to flash "RESET?" Do not proceed until this happens.
   
6. Release the dash button and push it again to confirm. You won't need to hold it - the display should change immediately and your service indicator will display five green LED's.

SOURCE: reset oil service light 318ti 96

You can also take a paper clip (can mess things up, but I use it) And have it touch the 7th & 19th pin inside the service port.