Spark plug gap
SOURCE: intercooler removal diagram on subaru 1995 tt ej20 bg5
If your havinf any trouble I suggest you can pick up a repair manual from any part store and if you feel like spending around $26 you can get alldata online for you car for a year I just did it for some wiring diagrams and it helped me out bigtime good luck
SOURCE: Not as easy to change as any of my other cars. Do I have to remove the motor mount?
Not easy without proper plug wrench. If not available then I use a plug socket and 1 " extension. Reach them in first onto the plug, then put ratchet on. When I re install I use a small piece of hose that the plug sets in to start the treads. The hose won't allow you to get enough torque to strip the threads but will start. Good luck and try to have paitience.
SOURCE: where are the spark plugs in subaru legacy gt
Subaru's are horizontally opposed engines. This means that the cylinder heads are actually pointed out toward the wheels.
If you look out close to where the engine and the inner fender meet, just a little in going back to the center, you will find two on each side on the 2.5 non-turbo. These have plug wires going to them.
On a turbo, the plugs are actually right in the side of the engine, going into the tops of the cylinder heads below the ignition coils which you remove first, to get to them. The same is true with the 3.0 engine.
SOURCE: 1992 SUBARU LEGACY WILL NOT START
It sounds like the fuel pump might be bad. I had the same issue, exact same one and it seems to be the pump.
SOURCE: how do i remove a stereo from a 98 subaru legacy
to start you have to pull out your cup holder and unscrew two screws with are holding it in place .then you can pop out the upper an then the lower trim panel .under the lower panel you will see four screws holding the radio .Take em out ad disconnect the antenna lead and electrical connectors.
138 views
Usually answered in minutes!
×