SOURCE: water pump replacement procedure 2005 2500 dodge with cummins diesel
take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.
SOURCE: where is oil pressure sensor located on 2001 dodge 2500 cummins?
Hello mhak330: My name is Roger and I can give you the answer to your question. Locate the ECM on the drivers side of the engine.look for the bottom bolt holding the ECM. To the right of the bolt you should see the oil pressure sender unit. Should you need further help please just ask. Please rate the quality of your answer. This way we know you received helpful information. Thank You for using Fix Ya. Roger
SOURCE: I need a diagram show me how to replace the
HI. The first link will be the routing with the AC, and the second link will be without the AC Compressor. Click below to access both diagrams.
CLICK HERE FOR THE ROUTING WITH AC.
CLICK HERE FOR THE ROUTING WITHOUT AC.
SOURCE: How to replace front wheel bearing on a 2002 Dodge 1500
You take off the right tire. You have take all the bolts out from underneath the
SOURCE: BAD BEARINGS ON AC CLUTCH ON A 2000 DODGE DURANGO
Buy a whole new clutch for about $200. You need a special puller to remove the old one if you intend to refurbish it. It's not worth the effort. Just remove the clips and knock the old one off with a hammer. Chuck it away and replace with a brand new clutch assembly.
73 views
Usually answered in minutes!
×