My question is...Since the only codes showing on OBD are 2 seperate p0705,both related to transmission selector switch(possible short/harness corrosion,etc)would that have put my car into limp mode?I accelerated from a stop at a red light and the tranny was suddenly in 2nd gear...Drove two blocks and pulled over. Coded the car and only 2 p0705 codes show up.Why would my car go into limp mode over this?Tranny had no symptoms,no other symptoms previous to this incident.
EOBD II Error Code: P0705
Fault Location:
Multi-Function Transmission Range Switch - Malfunction (PRNDL Input) - Implausible Signal
Possible Cause:
Wiring/Connectors from/to Multi-Function Switch faulty.
Multi-Function Switch faulty.
Engine control module (ECM)/Powertrain control module (PCM)/Transmission control module.
Possible Solutions:
Check Wiring/Connectors from/to Multi-Function Switch.
Check Multi-Function Switch.
Check Measuring Value Blocks.
Testimonial: "Appreciated!"
1,095 views
Usually answered in minutes!
×