How to access the cabin filter
SOURCE: How to remove and replace cabin air filter 2007 se crew cab
If you haven't figured it out yet, try the two links below. They have pics and diagrams. I haven't done this yet but, Nissan suggesting to have it done. (Sitting in the dealer having oil changed as we speak. They want $90 to replace the 2 filters.) I'm planning on doing it myself to save about $70. Doesn't look too difficult - just a little time. Parts are about $22 at local parts store. hope this helps. (Won't be back on this forum. So won't see any response you submit back).
http://www.clubfrontier.org/forums/f23/cabin-air-filter-replacement-29892/
http://www.nissanhelp.com/diy/altima/projects/nissan_altima_in_cabin_filter_replacement_procedure_1.htm
SOURCE: trying to change the cabin air filter
1. Open glove box
2. Unhook elastic retainer on right side
3. Locate the two "stop tabs", one on the upper left and the other on the right side. Push both to the left to clear their stops and the glove box will swing down, allowing access to the filter cover.
SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter
I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
SOURCE: 2000 nissan frontier knock sensor code & distributor
no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing
138 views
Usually answered in minutes!
×