Get solution for this online at www.reliable-store.com and get complete guide on whether to repair or not, service
it, and how to repair etc
SOURCE: 1996 toyota 4 runner 4x4 6cl key gets stuck in ignition, how do I replace ignition starter switch?
Just a thought , if the gear stick is not in park the key cannot be removed from the ignition I found out when I left the car in nuetral .
SOURCE: BACK DOOR HANDLE BROKEN.. HOW CAN I OPEN?..OR REPAIR?
I have had the same issue twice...My mechanic was able to open the hatch from the outside using an offset screwdriver. When the handle breaks you have a small opening that you can insert the offset screwdrive in...You can feel around and find the actual trigger that releasese the lock....You have to push down on it...and puff it will open..
The reason this happens is that the lock gets gummed up and rusts...It is a porr design...I make sure I lubricate at least once a month to enssure it does not get gummed up
SOURCE: brake pedal sinks 1-2 inches while holding
You either got a break fluid leak somewear or the master cyl. is bad.
SOURCE: 2003 Toyota Tundra Limited Stepside truck. No Brake light
Hello.
We would suggest that you look at the wiring connector under the bed, that feeds the taillamps.
You will probably find a coroded wire in the connector. If the 3rd brake lamp works, all of the fuses and switches are good.
Testimonial: "All connectors were fine. It ended up being that both brake light blubs blew at the same time. Thanks"
No need to panic rush through this procedure, just do it right. Haste makes waste.
1. Simultaneously depress and release brake and accelerator pedals 1 time.
2. Insert an original Master Key into the ignition but do not turn it.
3. Within 15 seconds depress and release accelerator pedal 5 times.
4. Within 20 seconds depress and release the brake pedal 6 times and remove key.
5. Within 10 seconds insert New Key into ignition but do not turn it.
6. Within 10 seconds depress and release the accelerator pedal 1 time.
7. Now sit and wait for about one minute until the security light in the center counsel stops blinking and turns off.
8. Remove new key and depress and release brake pedal 1 time.
9. Test your key now. It should work if you followed the instructions. If not, you may want to try the following instructions:
This procedure is for 2002 Camry and most other models in this year of Toyota. In the future always give the model as well as year and make. Thanks
62 views
Usually answered in minutes!
×