Where is the sensor
SOURCE: Cylinder number for firing order for 1995 Isuzu Trooper
Hi,
Assuming your 1995 Isuzu Trooper is using the 3.2 SOHC engine, the firing sequence would be as shown here.
. This was originally posted here. An actual image which was originally posted here.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: isuzu trooper problem!with a 00 3 litre diesel engine not starting
Was it lined up right as the trigger point for the sensor is important.Is the fly wheel fitted one position only that the bolt holes line up or will it fit no matter which position it bolts up Line up the flywheel trigger with the sensor after you have put the engine to Top Dead Centre.Put at tdc and see if the trigger and sensor are together.
SOURCE: firing order 1995 isuzu rodeo 3.2v6
123456 IS THE FIRING ORDER... RIGHT BANK (RIGHT AS IN SITTING IN THE DRIVERS SEAT NOT STANDING IN FRONT OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS HELPS
SOURCE: isuzu trooper 3 litre diesell oo year!
Set the engine on #1 tdc and the small half moon cut out on the flywheel goes at 6 o'clock . The sensor is now set to read the crank angle .
This is for the manual gearbox ,if you got auto its at 12 o'clock.
172 views
Usually answered in minutes!
×