SOURCE: how to replace the thermostat in my 2001 pontiac sunfire
Drain some of the coolant until you are sure it will not spill over when you remove the hose.
Remove the hose from the radiator .(Top) Hose. follow the hose to the thermostat housing. Remove the hose by removing the clamps.the thermostat is located in the housing. remove the bolts holding the thermostat housing. remove the housing. be careful to notice the position of the thermostat. Make sure you get the proper degree thermostat . Ask the vendor. give as much info as possible. mainly the size of the engine. remove the thermostat. You will get a new gasket with your new thermostat. Clean off the sufaces of the thermostat housing before installing the gasket.use a little grease to hold the gasket in place. and reinstall the new thermostat. replace housing and hose and refill with antifreeze/coolant. i hope this works for you and you vote for my answer.
SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter
Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger
SOURCE: Where is the coil pack located on a 95 pontiac sunfire
It looks like this:
Your car takes two of these....and this is its location....look where the white arrow is pointing:
The ignition coil assembly is locate on the side of the block towards the firewall and under the intake manifold-2.2L engine
SOURCE: Were is the thermostat located in a Pontiac Sunfire 2000?
Hi:
Your thermostat is located under the thermostat housing, which is what the upper radiator hose clamps to on the top of your engine. Basically, you need to start with a cold engine, drain your radiator, then unclamp the upper radiator hose from the engine. Remove the bolts from the thermostat housing, and gently tap on it to remove it. clean up the mounting surfaces on both the engine and the housing, and install a new thermostat, and new gasket. tighten to proper torque, reconnect the radiator hose, then refill up the radiator and cooling system.
Testimonial: "Thank you, very helpful"
459 views
Usually answered in minutes!
×