Code coming up
SOURCE: I have a 2005 gmc canyon. Occassionally it will
it's probably the transmission and u might have to change ur fuel pump also
SOURCE: how do i change the o2 sensor on a 2005 gmc canyon
It is a 7/8 ths Sized Wrench needed for it and you Simplt Unplug it and remove it and replace it. If you see a Problem with this Method , there IS a SPECIAL SOCKET for 02 Sensors and Same Procedure just with A Socket / Extention / Ratchet.
Testimonial: "Thanks "
SOURCE: fan control only works on high
Replace the blower motor resister,it is mounted right next to the blower motor,it has a lug with about 7 wires on it.Just unplug it and remove two screws to remove the resister.This controls the speeds for the blower motor.The blower motor is the cause of the resister failure.Even if the motor seems to sound,and run fine,it is pulling to many amps.
SOURCE: how do i add differetial fluid to A 2005 GMC
There is fill plug on the passenger side of the differential drive shaft side where the axle tube meets the differential housing. Your going to need a 3/8" ratchet with the extension and a hammer. Once you get the ratchet with the extension on the fill bolt, which is a square bolt that the extension fits right in. Use the hammer to tap the ratchet to break the bolt loose from the differential, remove the bolt once it has loosen enough with just the ratchet. The Canyon must be leveled to fill the differential, fill till the fluid starts to flow out and reinstall the fill plug. Don't over torque for future fluid check, the bolt is tapered so it will not leak. Good luck and hope this helps.
Standard Differential, Front......GL-5
ALL TEMPS......75W-90 Synthetic lubricant, GM part no. 12378261,or equivalent product formulated to meet GM specification 9986115.
Standard Differential, Rear......GL-5
ALL TEMPS......75W-90 Synthetic lubricant, GM part no. 12378261,
or equivalent product formulated to meet GM specification 9986115.
Differential, Front..........1.5 liters
Differential, Rear..........1.6 liters
Differential capacities varies between 1.6L-1.8L (3.4-3.8
pints) on the rear differential
SOURCE: IDLE CONTROL SYSTEM CODE PO506
You need the idle control solenoid replaced. It is the dealer that will fix it for you.
Good luck.
Testimonial: "THANKS FOR YOUR QUICK RESPONSE / WALLY"
233 views
Usually answered in minutes!
×