MB CLK230K with Code P0341

The codes signify issue with the same component.

P0341 What the P0341 code means. P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor.

P0341 OBD-II Trouble Code: Camshaft Position Sensor Circuit ...

P0342 Code: Camshaft Position Sensor "A" Circuit Low

https://www.carparts.com > blog > p0342-code-camshaf...
Dec 15, 2021 - P0342 is a diagnostic trouble code (DTC) that stands for "Camshaft Position Sensor 'A' Circuit Low." It basically means that your PCM is not ...

Check out the links below. They contain a fair explanation of what might be going on and a checklist of things to look at.

https://www.obd-codes.com/p0340

https://www.obd-codes.com/p0341

could be sensor or wiring. Does engine run rough or stall?
check out:
https://www.yourmechanic.com/article/p0341-obd-ii-trouble-code-camshaft-position-sensor-circuit-range-performance-by-jay-safford

Here's a link on your P0341 code. http://repairpal.com/obd-ii-code-http://repairpal.com/obd-ii-code-P0341

his P0341 code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal.

Read more at: http://www.obd-codes.com/p0341
Copyright OBD-Codes.com

code p0135 refers to a HO2S sensor 1 bank 1 heater control ---circuit malfunction- ===causes ---fuse --wiring and sensor
the other code p0341 would point to your problem It refers to camshaft position sensor(CMP) sensor A bank 1 --range / performance problem===causes --insecure sensor /rotor---air gap---wiring - CMP sensor
check that the rotor is fixed properly , that there is no dirt in the air gap and adjust the air gap. If it still plays up replace the sensor.

Hi, p0341 is cam shaft sensor. replace sensor that should fix your problem.

ok now for starters, we will go with the most probable:P0341 crank position sensor. chances are it needs to be replaced. 2nd your check engine light has probably been on for a while right?! the P0133 is an o2 sensor code and would probably be good maintenance(but get it to run first. 3rd P1599 refers to it stalling out which if it died while running would most likely trigger this. and last but not least either your coolant level switch is faulty or you really do have low coolant. let me know.

a p0341 code mean cam reference performance, really it means you have a secondary ignition problem,,,,like a bad ignition module
a bad crank sensor
a high resistance spark plugs,do not use bosch platinum plugs in these cars
high resistance spark plug wires,,,i work at the dealer and the first thing we do is replace the spark plugs and wires if that dont work we replace the crank sensor,if thatdont work we reaplce the ignition mondule,and by then your fixed and you started with the cheapest items first,,,i would try plugs and wires and a crank sensor,,,,wires $50 plugs $14 crank sensor $37

p0341 on a scanner means something is wromg with the camshaft position sensor have it checked