Cars & Trucks Logo
Bill Tupper Posted on Mar 24, 2014

Olds 98 regency

Someone tried to break in the car and destroyed the door locks, I would like to change them or the complete door handle system,I cannot seen to get at any hardware holding everything in Place

1 Answer

Pukaman

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

  • Contributor 29 Answers
  • Posted on Mar 24, 2014
Pukaman
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Joined: Aug 21, 2009
Answers
29
Questions
0
Helped
7757
Points
65

You have to take the inside door panel off on most cars. On some you just open the door and their is a clip in the door jamb. I am not sure if your car has this. The Oldsmobile (GM) has good locks though. Very difficult to pick. Purchase a complete lock set off of the internet that are keyed the same. Take off the inside panel. (a few screws and lots of clips) The window must be down to remove the panel from the window hole. You will have to reach up and grab the clip on the back of the lock and pull it towards the side. (prepare for knuckle cuts and bruises) The window must be up to remove the clip from the lock. There is a tool for doing this, but it is expensive. I usually use plyers. Good luck.

Some locks are held in place by a nut. (10mm) but I am pretty sure yours is a clip.

5 Related Answers

matney68

Donnie Matney

  • 426 Answers
  • Posted on Nov 11, 2009

SOURCE: 91 Olds 98 Regency elite once in a while the

Based on the information you have given to this point, I am just going to give you a few possiblities. Have you had a tune up done recently? Air filter been checked or changed? I am not in any way trying to sound sarcastic so I apologize if I come off that way.Those would be my first things to inspect if I were ask to look at your car. I would also check fuel pressure and inspect the fuel pressure regulator.I would consider these things and go from there. I Hope this helps you but please let me know if you need more information on what to do next but I may need some more information at that time also .

Ad

Anonymous

  • 6 Answers
  • Posted on Sep 22, 2009

SOURCE: 1991 oldsmobile 98 fuel filter replacement location?

my fuel filter is located right behind the pass side tire on the inner side of the frame.

Anonymous

  • 6 Answers
  • Posted on Dec 19, 2008

SOURCE: Door handle linkage disconnects

You'll have to remove the door panel,yes the whole thing,and look for any broken or missing parts in your door latch/lock linkage.Be careful not to break any wires that power your windows/locks while removing the panel.It may be just a plastic clip that holds the linkage together has fallen off.Check in the bottom of the door well for parts that may have fallen down there. A manual from the library or online is a big help here.

Anonymous

  • 617 Answers
  • Posted on Dec 15, 2009

SOURCE: I have a 1994 olds 98 regency. I changed the spark

07e78ac.jpgWithout a scan tool bridge the pins,turn key to on,not start and count the 'service engine soon' blinks to retrieve the codes.Good luck!

Anonymous

  • 395 Answers
  • Posted on May 22, 2010

SOURCE: 98 olds regency fuel relay were is it

its under hood on side panel it's black take top off look for relay that says fuel

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Newbie here! How to install fuel pump on 96 olds regency elite?

You might benefit from the 96 Regency Elite factory service manual purportedly available by a download for $22, if scrolling through pages or using CTRL F to hunt through a PDF is something you are comfortable with. I have no idea if it tells you to check for rust in the fuel tank. https://www.tradebit.com/filedetail.php/281883502-1996-oldsmobile-regency-service-and-repair-manual

The Haynes group is of course more familiar and there seems an aside mention of the 96 being covered in spite of the title. https://haynes.com/en-us/oldsmobile/regency/1997-1998

Regarding videos, I encounter such for the Olds Bravada and the Olds Aurora, both 96 models: https://www.youtube.com/watch?v=dO3QkeMTwP0
This experts advice bears looking at: https://www.justanswer.com/car/1wohy-replace-fuel-pump-remove-gas-tank-1996.html

General advice about replacing Olds fuel pump: https://www.yourmechanic.com/estimates/oldsmobile/regency/fuel-pump-replacement

https://www.walmart.com/ip/Fuel-Pump-Compatible-with-1995-1996-Oldsmobile-98-Regency-Elite-FWD-Sedan-4-Door-3-8L-V6-Naturally-Aspirated-OHV-GAS-1994/1595603100




0helpful
1answer

Does the 98 Toyota Sienna have a transponder key ignition

Yes it does, and programmable fob

https://www.carandtruckremotes.com/1998toyotasiennakey.html

Program Remote
PRESS the LOCK and UNLOCK buttons on the remote simultaneously for 1 second. b. PRESS and HOLD the LOCK button for 2 seconds. The Door Locks will cycle LOCK/UNLOCK to indicate successful programming of the remote.
1998 Toyota Sienna Keyless Entry Remote Fob Programming ...

https://www.google.com/search?q=98+toyota+sienna+transponder+key+programming

..
0helpful
1answer
0helpful
2answers

My driver side door wont open from the outside but will open from the inside. How do i fix this

Well first remove the door panel then look for a link that joins the lock to the door handle, you will probably find that the clip that holds it on has broken.
7helpful
1answer

How to replace 1991 olds regency 98 elite crankshaft sensor?

Remove the crankshaft pulley,the harmonic balance,with a puller made for this,then you can replace the sensor,and align it,if it is not aligned,it will break it.
5helpful
2answers

Fuse box diagram for 1990 olds 98 i want to cut

Review this Wiring Schematic about Olds 98 ('89, '90 & '91):
1989 1
1989 2

1990 1
1990 2

1991 1
1991 2

I really hope help you with this (remember rated this help). Good luck.
0helpful
2answers

02 GMC Denali XL 6.0L drver's side door lock was

the lock should come out of the handle. usually there is a clip holding it in. sounds like its broken and you will need another handle, a locksmith should be able to get another lock and make it fit your old key. The dealer is the only place to get a new handle from as far as I know.
Not finding what you are looking for?

113 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...