2000 Chevrolet Tahoe Logo
s
shawn sones Posted on Mar 22, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Fuel tank diagram for relay

Replaced fuel pump has a different relay plug diffarnt colar wires

1 Answer

David Longobardo

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

  • Expert 77 Answers
  • Posted on Jul 17, 2014
David Longobardo
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

Joined: Jun 11, 2010
Answers
77
Questions
4
Helped
22694
Points
178

Go online and search for a service manual...there are many sites for this.

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Apr 26, 2009

SOURCE: fuel pump or fuel pump relay on 1989 Chevy Suburban 1500 4x4

Check in relay box on passenger side near firewall for fuel pump relay.
By -pass, no such luck that I' aware of, sorry.

Ad

Anonymous

  • 253 Answers
  • Posted on Apr 30, 2009

SOURCE: 2001 Chevrolet Impala 3.8 fuel pump wiring diagram

The wires should be grey, orange and black, purple, and a black wire. The purple goes to purple, grey to gray. The orange and black goes to the small black wire on your car harness and the black goes to the bigger black.

Anonymous

  • 34 Answers
  • Posted on Jun 20, 2009

SOURCE: 1997 chevy silverado 1500 350 vortech, new fule pump not working

before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.

shocktroop40

John DeCosta

  • 155 Answers
  • Posted on Aug 03, 2009

SOURCE: fuel pump wiring diagram for 1998 chevy express

Well if theres power going to the relay but not out, then you need a new relay. If theres power in and out of the relay, you might need a new fuel pump. The electric fuel pumps inside the tank are actually lubricated by the fuel as it pumps it, and if it runs dry long enough, it can burn out the pump

duane_wong

Duane Wong

  • 6826 Answers
  • Posted on Aug 17, 2010

SOURCE: fuel pump on 1994 caprice not pumping fuel. its a

I've run into new pumps that didn't work. If there is power at the pump and it is not pumping, then the pump should be replaced, again (under warranty).

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2010 Chevy traverse fuel pump wiring diagram plug to pump

Does the vehicle have GDI - gas direct injection? Why do you want to test fuel pump ? Do you know it's easiest to test at the fuel pump relay?

GM Fuel Pump Relay Testing - YouTube
0helpful
2answers

No fuel getting to motor so no start. replaced pump fuses and relays all good. there is spark

you will need to check the plug to the pump on top of the tank. check for voltage. then if no volts trace the wires back. also you should check the relay have some one at the relay listening to see if it clicks when you turn the key. no click no volts no volts may be a warn out relay, if it buzzes change it.
0helpful
1answer

Getting no fuel to the engine. some one zero out the computer. could not read the codes if any.

Fuel pump? If you don't hear it, you need to check if the pump has failed, or if there's a problem in the circuit to the pump. To check, pull off the fuel pump tank connector at the gas tank, and check for power on the fuel pump wire while a helper is cranking the engine over. If you have 12 volts there (can use a voltmeter or a test light), the pump has failed and need replacing. If no power when cranking engine, the fuel pump circuit will have to be diagnosed. You will need a wiring diagram of the pump circuit. It is a fused circuit, so first check the fuse. If fuse is good, find the fuel pump relay and hold a finger lightly on it while helper turns the key to on. The relay should click when key is turned to on. If it does, pull the relay out and check that the power feed for the pump is available on one terminal where the relay plugs in. Use the test light probe and check all terminals-one should be "hot at all times". If none have a signal (key is OFF), then power is lost between battery and that relay terminal. From here on, you will need a wiring diagram...Good luck.
0helpful
1answer

Wiring diagram

Then the fuel pump has failed most likely. It is electric of course and located inside the fuel tank, the fuel tank must be removed in most cases to replace the fuel pump, and don't forget to replace the fuel filter
0helpful
1answer

1982 Corvette fuse relay location and do you have to drop the gas tank to replace the fuel pump?

Yes, you need to remove tank.
There is a fuel pump test connector, either a single wire connector in engine compartment, left side, OR terminal G of the ALCL, the diagnostic test connector under the dash. Put battery voltage there and see if pump works.
Diagram also shows a fuse for the pump, probably in the dash's fusebox.The relay is probably is there also.
0helpful
1answer

No fuel pressure asd&pump relays energized

The fuel pump relay won't energize if the ignition is bad, or the fuel safety cut out is bad. Don't know what Dodge uses. Ford has an inertial switch in trunk. Many cars use the alternator. Some use extra wires to the oil pressure sender. Try looking at the wiring diagram on relay side, and jumper the outputs where relay plugs into, bypassing the relay completely. The pump should hum and you should get pressure. If not, make sure the tank isn't buiding up vacuum, and make sure the power and gound are good at the pump.
0helpful
1answer

Fuel pump not running. put gas in air intake and engine runs about 1/2 minute. I have 2 different haynes manuals but the schematics don't match my car.. Manuals have relay with 1 wire going to fuel pump....

CHECK FUEL PUMP AND FUEL INJECTOR FUSE AND CHECK FUEL PUMP RELAY.IF ALL IS GOOD SCAN TO SEE IF YOU HAVE PCM FAULT CODE.IT CONTROLS FUEL PUMP DRIVE CIRCUIT.
2helpful
2answers

1997 chevy silverado 1500 350 vortech, new fule pump not working

before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.
Not finding what you are looking for?

66 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...