My chevy k10 pickup 4x4 short bed i dont know if it has turn signal i the front there is a yellow bolt hangin but there is no were to asemble it and i need to know for the inpextion on light and brakes ?
SOURCE: brake caliper removal
Sometimes they use a T-50 torx bit, and sometimes they use either a 15mm or 18mm bolt, however the caliper bracket is a 21mm bolt
SOURCE: brake line for 94 Chevy S-10 pickup
thats a common placc for them to rust out you will need 10 feet of 1/4 in. brake line that will go front to back
SOURCE: rear brakes locked up. 1990 chevy c1500 2wd pickup
did you see if they need replaced?
and also the emergancy cable may be froze
SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
SOURCE: 2007 chevy silverado brake lights dont work
I had the same problem! I used a piece of wood to keep the break pedal depressed and then started to remove one of the break lamps and to my surprise it came on! Same thing on the other side. So I did not seat (bottom out) the lamps in their sockets and both break light are now working properly. I had a similar issue last spring but that time only one light was out. I put in a new bulb and it still did not work so I messed around with it a little more and it started working. Never did figure it out until now. Hope this helps!
188 views
Usually answered in minutes!
×