Need Location of Oil Pump
SOURCE: 2002 Chevy Avalanche Oil Pump
oil pump is on front of engine you ewill need to pull crank pulley and fan shroud.
SOURCE: oil change 2007 chevy malibu maxx
2.2L takes 5 quarts
3.5L and 3.9L take 4 quarts
Both quantities are with oil and filter change
SOURCE: how do i change the oil pump on 98 chevy malibu
Are you sure it's the oil pump, Most of the time it's the oil sensor that has gone bad. Just trying to save you lot's of job since the oil pump is at the bottom of the engine in the oil pan. You can check by having the engine running and looking down the hole where the oil filler cap goes. Rev the engine up a bit and you should see oil splashing around which means your oil pump is working. Your oil pressure is created by the crank shaft. Good luck
SOURCE: i am replacing the oil pump on a 98 chevy malibu,
take loose the motor mount bolt and jack the front of the engine up to clear the oil pump and remove the pan,.the bolt the runs thru the center of the mounts ,the easiest way ,hope this helps you, thanks robert b.
SOURCE: What are the step by step instructions to change
Find the oil drain plug, remove, drain the oil into a pan, reinstall the drain plug a tighten, locate the oil filter and remove, check mounting surface to make sure the old gasket didn't stick. Coat the new filter gasket with oil and install hand tight. Refill the oil, make sure that you do not overfill. Start enigne for about a minute, shut off and double check the level, and that the filter and drain plug do not leak.
Some engines can be difficult, to identify the location of the drain plug and filter. There are thousands of configurations out there, If you are not familiar or can not locate the plug and filter, take the vehicle to a shop for service.
715 views
Usually answered in minutes!
×