Turn signals work high beam light works but no dash lights
Http://willcoxcorvette.com/instructions/headlamp_and_wiper_small_parts_function_2.pdf
I’m happy to assist further over the phone at https://www.6ya.com/expert/richard_9a19ee73dfa4686a
Look at the head lite switch for a burned resistor.
SOURCE: low beams don't work
there is two things that could be wrong .. check under the hood for your power distribution box .. its black and 3 inches wide and about 8 inches long .. this contains your relays. and some fuses. on the inside of the lid it tells which one is which.. look for low beam relay .. if it is ok check your low beam bulbs and make sure they arent burnt out.. these two things should fix your problem .. or at least one of these should .. holler if you need more. Jerry
SOURCE: REAR TURN SIGNALS WORK BUT MY BRAKE LIGHTS DONT
Replace the turn signal switch. If you want to prove this have someone stand behind the car with your foot on the brake. Then wiggle the turn signal lever. The brake lights should blink. This is a real common problem with W body. I have replaced two on my cutlass plus tons more at my shop.
SOURCE: While driving down the road my headlights will
replace the main headlight switch and the connector to that switch, the connector can be obtained from the dealer only in most cases.
SOURCE: i have a 2001 chevrolet cavalier and the high beam
Sounds like its a problem with the light switch handle. Had it myself as well...
If you're savvy enough around car electronics take out the light switch handle, take it apart, find the problem and fix it. Inside the handle-switch you have several slide-switches and some double action slide switches.
Otherwise - get a different switch from a local junkyard or get a new one from your dealer.
Good luck.
232 views
Usually answered in minutes!
×