94 q45 what color wires for starter circuit - 2001 Ford Escort ZX2

Could be a short circuit on ignition wires or a broken ignition switch. Or a short circuit on starter wires or inside the starter motor itself.

It could be the solenoid or the start circuit. To check, pull off the wire at the starter solenoid and use a test light or voltmeter to check for power on that wire when the key is held in crank position. It should have power- if it does, likely the solenoid is bad. If no power on the solenoid start wire, then problem is in the start circuit between the ignition switch and the solenoid-check the neutral safety switch, check for power out of ignition switch on the start wire, with key held in crank position, check starter relay for proper operation. All these items are in the starting circuit.

Its located in the under hood engine compartment fuse box.

There will be three same relays.One for fuel pump and other for horn and bit bigger one for starter controlling.

For more help regarding starter

CAR STARTER REMOVAL? TESTING

One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

-----------

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------

How to replace Starter on Infiniti Q45?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------

2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----

Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

• Oldsmobile starter solenoid replacement procedure?...

--------------------

• How to replace Oldsmobile starter moor?

----------

• Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

CAR STARTER REMOVAL? TESTING

One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----

How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html ----------- How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------
How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------
2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----
Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

• Oldsmobile starter solenoid replacement procedure?...

--------------------

• How to replace Oldsmobile starter moor?

----------

• Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============
For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----
These help links will help.
Click the link below:-----

How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html----------- How to replace starter in car? http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html
-----------How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html
---------- 2006 GM Montana: How to replace Starter Solenoid? http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html
-----Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?
http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html
----------

• Oldsmobile starter solenoid replacement procedure?...

--------------------

• How to replace Oldsmobile starter moor?

----------

• Oldsmobile starter motor testing?

-------------
Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?
------------These details will help.Thanks.

bottom, but the manual mentions a couple different procedures. See below.

4.1L Engine

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove or disconnect the following:
   
   Negative battery cable Steering gear and linkage assembly Harness connector Starter retainers Starter
   

To install:
Install or connect the following:

Starter Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm). Harness connector Steering gear and linkage assembly Negative battery cable
Alternate procedure:

1. Remove or disconnect the following:
   
   Negative battery cable Engine undercover Harness connectors Starter motor mounting bolt and nut
   
2. Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack
3. Remove starter motor

To install:

1. Installation is in reverse order of removal; observe torque values shown in diagram
   
   

Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45

Hello! The inhibitor switch needs to be adjusted or replaced...It is located on the manual control linkage of the automatic transmission shifter...The inhibitor switch has two "jobs"...#1 it acts as a starter relay and #2 it turns on your back-up lights...That portion of the switch (pins 3 and 8) wire colors Green/Black and Blue/White is staying closed...Guru......Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

verify that you have a fully charge battery and that you have the same amount of voltage at the battery as at the starter when the key is turned to the start position. If not repair fault at positive cable either at battery or at starter. If voltage checks good. Use a remote starter and turn key to the on position and try to crank over engine with remote starter. if engine cranks over. You have a defective starter solenoid and starter must be replaced.

Q45 4.1 ENGINE STARTER IS NEXT TO STEERING GEAR.

check you battery first.