Pollen filter replacement

Go here so you can find out how to replace and or clean the filter .
https://www.youtube.com/watch?v=8zFIRHp-NS courtesy of youtube . https://www.youtube.com/watch?v=8zFIRHp-NS

The pollen filter can be reached from your engine bay. There is a panel on the fire wall which you remove to get to the pollen filter

Hi Maria: Remove the glove box, then you will be able to remove the cabin air/pollen filter. If you need help removing the glove box, try You Tube and search "2009 Honda CRV dust and pollen filter replacement. You can purchase one from a Honda dealer online or aftermarket such as Rock Auto, etc. Take Care.

The filter will clean most of the pollen and other particles up. Just be sure to clean or replace the filter regularly. Some modern air conditioners will let you know when they think the s dirty and needs to be replaced usually located in the front if u have allergies id say wear a mask and if u talking about a car it's under dashboard u can't miss it

Audi A3 1.9 TDI m.y. 2006 ... 2011
Dust and pollen filter location:


Please do rate my response. Thanks!

2010 Audi A6 240 PS

Pollen filters replacement:
1. Remove the interior trim.


2. Remove the cover.



3. Remove the second dust & pollen filter, then the first dust & pollen filter.



4. Clean the dust & pollen filter housing.
5. Refit all parts in reverse order of removal.

The pollen filters are located in the HVAC box behind the glove box. While holding the glove box open, unclip the glove box damper (left side). Then remove the glove box stops on each side, flip the glove box down. Pull the pollen filter housing from the blower unit by releasing the clips on both sides. Replace the filter in the housing make sure the arrows printed on the new filter are pointing down. Reinstall all removed parts. -hope this helps.

how to locate and change the pollen filter for Toyota Avensis VVti 1.8 Petrol 2002

Dust and pollen filter, removing and installing
The filter is located in the right rear of the instrument panel under a cover.

Components of dust and pollen filter:




1 - Frame 3 - Filter element 4 - Plastic nut, 2.5 Nm (20 in lb ) 5 - Filter housing with seal Removing

• Push center cover -1- forward -arrow A- and lift up to remove.

• Remove screws -arrows-.
• Lift right plenum panel cover -1- and remove from clips at front and rear edge.
• Pull cover -1- toward center of vehicle and out of retainer in A-pillar to remove.

• Remove screws -arrows- and remove right closeout panel -1-.

• Remove rubber grommet -1-.
• Press tabs of filter housing in direction of -arrow-.
• Remove filter element with frame in upward direction -arrow A-.

Installing

• Guide frame -1- into first slot on left and right sides of new filter element.
• Press frame with filter into housing -2- and engage retainers.

Under the glove box.

Put the seat back all the way rearward (just to give you more room to move.

On the panel just directly below the glove box, there should be two Torx 25 screws. Remove those and pull that panel downward and rotate the right side back, that should release it from the kick panel on the left.

Now towards the back you should see the blower motor. Kind of an off white color and a black panel on the bottom of that.

It's held in with four gold colored Torx 25 screws. Remove those and the pollen filter should be in there.

If you have the thin pollen filter, you can get away with simply removing the two golden Torx 25 screws closest to you, carefully bend down the black plastic cover (carefully enough to squeeze the pollen filter past, I've seen people break them cause they do it too much).

If you have the thicker pollen filter, you have no choice but have to remove the four screws.