Check A LOT of fuses and they all checked out good. It's possible I missed one.
SOURCE: Hazard Flashers, turn signals and brake lights quit working
please check your flasher relay. it is normally a three prong relay box.
tnx 4 using fixya,
drcool
SOURCE: 1991 lincoln town carTail lights and turn signals stopped working
One of the tail light bulbs can be shorted internally. Replace the tail light bulbs first. Try this cheap fix first.
SOURCE: Taillights are not working
check for voltage in the socket. positive is the center connection. if you have no voltage there, then you may be right. Make sure that you check the wires.
SOURCE: 1998 Lincoln Town Car: No turn signals, 4 way flash, brake lights
If only your brake light in middle of rear window works then your other bulbs are bad. If brake lights all work in the back than bulbs are good. If you put turn signal on right or left and the bulbs light in front and back then you need to change multifunction light control box under dash. My understanding is it cost $600 new. So I would try used.
SOURCE: Park/Tail lights not working. Brake/signals are
Before going ahead and spending money on a new module, test it first. The module is located under the steering column. You'll find a Brown wire on one of the connectors (i just looked at a wire diagram). Do no disconnect anything. Back probe the brown wire, which is the power feed to your park lights. With the lights off, there should be 0 volts on you voltmeter. Turn the park lamps on, There should be 12V. If there is not 12V, disconnect the connector and try to check voltage at the pin that feeds to the brown wire, if still not 12V, replace the module. If you do get 12V, then module is ok, find where the 12v is being dropped before making it to the lamps.
640 views
Usually answered in minutes!
×