After atf change still having hard shifting from 1st to 2nd gear and sometimes from 2nd to 3rd and also from 2nd to 1st. no check engine light on.
SOURCE: slight miss in engine, hard shift from 1st to 2nd long 2nd gear
Check both O2 sensor(s) and catalytic coverter.. P0420 means catalyst below threshold. Also check the sensor at the transmission and solenoid.
SOURCE: hard shift from 1st to 2nd gear automatic
what year is vehicle please ?? as people often put it in wrong catagory ,if its mazada 2007 then its dealer only as a computer controls it all and the software is factory encrypted to stop general garages from repairing it .But check for a vacumn pipe loose under bonnet ,thin rubber pìpe from inlet manifold to gearbor or a diaphram switch,
SOURCE: 2002 Lincoln LS V8, gear shift shows E, check transmission light
sounds like tranny computer is bad take it to a grage and have a computer put on it cost about $50.00 to do this
SOURCE: 2000 mazda bogging in all gears especially in 1st and 2nd gears ?
Judging from what i know, the timing on the engine is probably a bit off, and i remember reading the exact same problem on another web site and that is also what they said. So just check the timing on the engine or have it checked by a mechanic if you don't know how to do it.
SOURCE: Transmission problem in E230 Benz
What you need to check is the transmission release bearing because if there is a clearance on the release bearing you will encounter this problem and also check the transmission oil.
I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482
293 views
Usually answered in minutes!
×