Both tail lights don't work turn signal and back up lights work but no stop light and no tail lights

There are a few possible reasons why your turn signal light is not working while your brake and tail lights are functioning properly:

1. Blown fuse: The turn signal lights are connected to a different fuse than the brake and tail lights. The fuse for the turn signals may have blown and needs to be replaced.
2. Turn signal switch: The turn signal switch, located on the steering column, could be malfunctioning and needs to be replaced.
3. Wiring issue: A wiring issue, such as a broken wire or loose connection, could be preventing power from reaching the turn signal lights.
4. Flasher relay: The flasher relay is responsible for controlling the turn signal lights. A faulty flasher relay could be preventing the turn signals from working.
5. Signal/light module: Some cars have a signal/light module that controls the turn signals, this could be faulty and need to be replaced.

Bad flasher relay or blown fuse. Does hazards work if not and fuse is good than flasher relay is bad

The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

TAIL LIGHT NOT WORKING

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.

---------

There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----

Turn Signal Not working

http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------

Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------

Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------

Turn signals not working on 1987 Jeep Wagoneer?

http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE

http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------

1994 Toyota Camry: Bypass Tail light Relay Circuit?

http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------

2008 Toyota RAV4: Replace Tail light Lens Cover?

http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html

--------

2003 Chevrolet S10 Tail light Fuse

http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------

Chevrolet Parking light and Tail lamp light Wiring diagram

http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------

Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------

These details will help.

Thanks.

Then you need someone who can,like a repair shop

first of all check and confirm whether in the fuse box separates the left from right side and see for blown fuse. or check for any disconnection on the rear light

There are several components of your 1997 Subaru Outback that can cause your tail lights to stop functioning correctly. To help pinpoint the cause of the problem, it would be very helpful to also check your front marker lights. If the marker lights are working, then we know that the problem is not the headlamp switch or the tail and illumination relay (located in the fuse and relay box).

The components to check are:

> Fuse #23 (20 Amp) in the Main Fuse Box.
> Fuse #5 (10 Amp) in the Fuse and Relay Box
> Tail And Illumination Relay
> Headlamp Switch

check for power at the wires going intop the tail lights, real common that the circuit board is bad, but unlikely both at the same time. The tag, tail lights and brakes are 2 different systems. Do the turn signals work normally? if so the wiring from the turn signal switch to the brake lights is GOOD. the stop light switch had\s a ORANGE wire that should have 12V if not ck STOP LPS fuse, when brake pedal is depressed, the WHITE wire is 12V (at the stop light switch) if that is OK, the turn signal switch COULD be bad. The wiring harness plug is near the back left under the tailgate, see if that is disconnected?

96 eclipse rs back tail lites and dash wont come on i changed the combination switch ,fuses,relays and bulbs and it still dont work what else can it be?