1991 Chevrolet Suburban Logo
Posted on Jun 13, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

DRIVER SIDE TAIL LIGHT BRAKE LIGHT OR TURN SIGNAL DONT WORK BUT P

PASSENGER SIDE TAIL LIGHTS AND ALL LIGHTS WORK WHAT COULD THE PROBLEM BE?

1 Answer

kirtec auto

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Chevrolet Master 1,348 Answers
  • Posted on Jun 13, 2009
kirtec auto
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: May 09, 2009
Answers
1348
Questions
0
Helped
596548
Points
4360

If you have the diagram,have a look for a ground problem.ground the assembly to the side that works.the other thing to do if you have a test light is check that there is 12 volts on off on the signal on one bulb pin and steady 12v on the run and stop lights.that means there is an open ground......

5 Related Answers

Darrell

  • 118 Answers
  • Posted on Jan 28, 2009

SOURCE: Tail light does not work

I hope you arent letting a simple thing like a burnt bulb ruin your day??Im not sure what you have checked so far but start with replacing the bulb,check the connector very good as this has been an issue on many makes and models

Ad

Anonymous

  • 1486 Answers
  • Posted on Jun 18, 2009

SOURCE: 2006 Ford Ranger. Rear passenger side tail light

Bad earth connection.Clean or replce wire.

Anonymous

  • 185 Answers
  • Posted on Oct 06, 2009

SOURCE: 2002 Toyota highlander passenger brake light not working

the brake light has its own bulb. you have to remove the tail lamp fromthe vehicle to replace the bulb. it is a double filiment bulb. make sure you replace it with the correct bulb or the warning lamp will stay on.

Jonah Oneal

  • 14092 Answers
  • Posted on Dec 14, 2009

SOURCE: tail lights work on both sides. turn signal and

check fuse to driver side turn signal lamp.check brake light bulb or replace bulb on driver side.also replace the front driver side turn signal bulb that is flashing fast.

Anonymous

  • 45 Answers
  • Posted on Mar 22, 2010

SOURCE: My dashboard lights are out, along with just the

could be fuses bulbs or loose wiring

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

2007 Uplander. The tail lights on the driver side will not come on, but they are working on the passenger side and the front. The brake light and turn signal work on the problem side and all the other...

GM doesn't have the best tail light setup. do you own a test light? You should start at the back. The turn signals and hazards use one bulb. The brake light uses another bulb. Remove the bulb and carefully test for ground and power. If it is there then it is either the bulb or related contacts. If power or ground is not there then unplug the tail light assemble and test for power or ground again. The tail light circuit board is notorious for going bad. Please start here and write back if you need further help.
1helpful
1answer

No brake lights and only 1 taillight works on driver side and no brake lights on passenger but I do have tail lights

Check your bulbs. There are two filaments in each bulb, one for tail light and one for the brake light, so it's possible to have a tail light with not turn signal or brake light.
1helpful
2answers

2011 Ford Escape driver side tail light not working correctly - lights are on but turn signal flash not working and neither is the brighter brake light

I would guess that you need a new bulb. Many of these tail lights actually have two filaments inside them, one that is used for a dimmer light (running light) and one that is used for a brighter light like (brake light, turn signal). The easiest thing to try (and probably the cheapest) would be to buy a replacement bulb and change it. Most places that sell automotive light bulbs will have a large catalog where you look up the make model and year of the car you need a light for and it will tell you which replacement bulb you will need. Then look in your cars manual to see how you access and replace the bulb.
0helpful
1answer

Drivers side tail light not working

Put the passenger bulb in the drivers side and see what happens, if it works buy a new bulb.
0helpful
1answer

No taillights park or dash lights

check park/tail fuse regarding dash ,park ,tail problem .brake light on passenger side is probably the brake globe needs replacing .Turn signals on passenger side could be globes or switch,check globes first ,if globes and fuse are ok ,may well be the switch especially if park switch and turn signals are on the same switch lever/stalk
1helpful
1answer

Tail lights work but not brake lights 93 toyota camry

The brake light side of the bulbs is powered by the brake switch and travels thru the turn signal switch.
If the third brake light works, I would guess the problem is in the turn signal switch.
0helpful
1answer

When i press brake pedal driver side brake light quits working but other wise it works fine?

That has a double filament bulb in it. One is for the tail light and the other for the brake and maybe the turn signal. If your turn signal flashes the tail light and not an individual turn signal bulb it will behave the same way. The way it works is that the tail light filament goes off and the brighter brake light filament comes on. The brake light half of the bulb is out. If you change it, change the passenger side too, it will do the same shortly if you leave it in. They tend to go bad in pairs. Good luck.
0helpful
2answers

Tail lights work on both sides. turn signal and

Sounds like you need to replace the drivers brake/tail light.
1helpful
1answer

2006 Ford Ranger. Rear passenger side tail light

Bad earth connection.Clean or replce wire.
Not finding what you are looking for?

274 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...