Heater and a./c and blowers not working 1993 jaguar xj6

Yes sir!

https://www.google.com/search?q=1993+Jaguar+Xj6%2C+4.0L+Firing+Order&tbm=isch&ved=2ahUKEwikk5Kz_NTyAhXvnnIEHecIBFMQ2-cCegQIABAA&oq=1993+Jaguar+Xj6%2C+4.0L+Firing+Order&gs_lcp=CgNpbWcQA1CRdFjjpgFg568BaABwAHgAgAFpiAGKBZIBAzUuMpgBAKABAaoBC2d3cy13aXotaW1nwAEB&sclient=img&ei=VNQqYaSZF--9ytMP55GQmAU&bih=937&biw=1920&rlz=1C1QJDB_enCA643CA644

..

its on the main power supply board.
and there are 2 fuses.
thanks

My 93 xj6 doesn't blow or anything but I found that if I kick the blower under the string wheel. It comes on. Then it's blowing cold on the dash and hot out the center counsel. Where do I kick to fix that? There are buttons that light up by the steering wheel. That look like the seat heater button. Is there a way to choose to make the thing blow cold in front and hot in back? 989-657-2563

may be the motor itself

Sounds like it could be the traction control light?

cannot find blower relay

its the computer behind the radio,they have a bridge connection in them that just passes the current straight through it doesnt do anything other than to confuse .run a feed from the heater fuse on either side of the floor well to the appropiate blower ,like right hand fuse to right hand blower and left hand fuse to left hand blower and it will all work ,speed control included

See here. I don't know if it's free.

check the fan speed resister block... located under the dash in the duct work near the fan. i may have failed

Robert

It more and likely is the servo motor (s) that are the problem, when you turn hot to cold and defrost they cycle the vents in conjuction and are a common failure on this model.
The ones that fail are accessible if you remove the right underscuttle panel and the glovebox.
Black motors with a double wire, usually have a red connector on the end.
JPTCAT